A Jaguar XJ wrapped in carbon fiber film starts with the finish, then the film line, then coverage. Carbon weave has a regular fabric pattern while forged carbon has small random flakes. A color change wrap covers every painted panel and leaves glass, lights and bright trim visible. The XJ is a large car, so a full wrap takes about 64 ft (19.5 m) of 60-inch (1.52 m) cast film.

Factory paint on the XJ should be clean and free of loose chips before carbon fiber film goes on. Every body line and panel gap on the XJ is a planned edge for the installer, not a place where film lifts by itself. Seams fall along sharp creases or hidden edges so the carbon fiber pattern stays as continuous as possible. The long roof and doors of the XJ call for patience: a rushed install shows in the weave alignment.

The carbon fiber film on the XJ is removable with heat and the right lift, and it leaves the factory paint as it was. Hand wash with a soft mitt and pH-neutral soap, and avoid pressure washers aimed at panel edges. The finish needs no wax because the film is not a painted surface.