A Tasman wrapped in gold starts as a color change over the factory paint, and the wrap can be removed later without leaving adhesive behind. Decide first between a full wrap and a partial job like the roof or hood, then choose the finish and film. The cab and the bed are wrapped as two separate pieces, so a full wrap covers both outer body sections. The wrap does not cover the inner bed surfaces, which stay as they are from the factory.
Factory paint on the Tasman needs to be clean and smooth before any wrap is applied, because small chips or rough spots show through the film. The wrap film is stretched into the body lines and cut at the panel edges, and the seams follow the factory gaps between panels. On the Tasman, the bed and cab meet at a gap that is naturally covered by the film edge, so the seam sits where the body already has a line. Most installers also remove badges and handles to tuck the film behind them for a cleaner edge.
A gold wrap on the Tasman is removable, and it is best cleaned by hand wash with a soft sponge or mitt. Automatic car washes with brushes can lift the film edges or scratch the surface, so they should be avoided. Use a pH-neutral car shampoo and rinse with low pressure to keep the film tight at the edges. Drying with a microfiber towel prevents water spots on the gold finish.


