Choosing an IS F wrapped in color shift film starts with the finish before the exact shade. Gloss, satin and matte all shift color, but they catch light at different strengths. A full color change on this sedan needs about 52 ft (16 m) of 60-inch (1.52 m) film. Keep the direction of the film consistent across every panel so the shift stays even.
Factory paint condition decides how much preparation an IS F color shift wrap needs before film goes on. Stone chips and scratches show through the film, so they are repaired first on the 183.5 in (4,660 mm) body. Good vinyl hides small marks, but a deep edge can lift and create a visible seam. The color shift finish makes seams less obvious than on a flat film because the eye follows the changing shade.
A removable color shift wrap on the IS F can be peeled off by hand without leaving adhesive on the paint. Use a pH-neutral shampoo and a soft mitt for every hand wash. Do not point a pressure washer at film edges, cut-outs around sensors, or the seams of this wrap. A ceramic coating made for vinyl adds slickness and keeps the shift bright.

