A Lichi A01 wrapped in white is a full color change that covers every exterior panel you see. Plan the finish first because matte, satin, and gloss change how the small body reads in daylight. Then pick a film whose tone stays close to white rather than cream or silver. A partial wrap stays an option if you want white only on the roof, hood, and mirrors.
Factory paint under the wrap matters most at panel edges and inside door jambs. The A01 has two long side doors, so each door is one large piece of film with no seams across the middle. The tailgate carries the rear glass in it and the film ends at the edge of the glass. Clean, smooth paint lets the film sit flat without marks showing through.
A white wrap on the A01 is removable and leaves the original paint intact when removed correctly. Hand wash the car with mild soap and a soft mitt after the film has settled. Avoid pressure washers aimed at edges, the charge port door, or the film edge around the tailgate glass. Drying the long door panels by hand keeps water from sitting at the lower seams.


