Every eDeliver 7 wrapped in camo or patterned film starts with the finish, then the film line, then whether the job is full or partial. The pattern must run one way and line up across the sliding doors and the rear panels. A color change on 90 ft (27.5 m) of 60-inch (1.52 m) cast film needs more material when the pattern repeats are large. The wrap shop will plan the panel cuts around the door tracks from the start.

The factory paint does not need to be perfect before a camo and patterned wrap. Small chips and swirls disappear under the film, and any clean, cured paint will do. Seams fall on factory panel gaps, along the sliding door cut lines, and at the roof rails. The installer will set the pattern repeat first, so the doors and the side panels match when they are closed.

A camo and patterned wrap on the eDeliver 7 is removable when the film is removed by a wrap shop. The adhesive is made to release from factory paint without leaving a residue. A hand wash with a mild detergent keeps the pattern clean and stops edge lift. Do not use a pressure washer on the film edges or the charge port door.