A Mazda 6 wrapped in color shift film begins with three decisions: finish, film, and coverage. Pick the finish first, since a gloss flip and a glitter flip read differently on curved panels. Then choose the exact film by its color pair, viewed on a curved sample in daylight. Last, decide between a full color change wrap, which recolors the whole body, and a partial job.
A Mazda 6 wrap takes about 52 ft (16 m) to 62 ft (19 m) of cast film. Parking sensors and cameras on some trims of the two newer bodies each need a precise cut-out. A careful installer cuts these openings without a blade touching the factory paint. A 60-inch (1.52 m) roll covers most Mazda panels in one piece, which keeps seams to a minimum.
Care of a Mazda 6 in color shift film starts with a hand wash using a soft mitt. Keep pressure washer jets well back from film edges, which can lift under a close spray. Skip wax with abrasives, and use a sealant labeled safe for vinyl instead. Because the wrap is removable, a scratched panel can be rewrapped without redoing the whole car.



