A Biante wrapped in carbon fiber film is a full color change, so every panel choice starts with the pattern direction. The sliding door tracks stay bare and set fixed cut lines along each side. The tall 72.2 in (1,835 mm) roof needs a platform or step for safe install. Pick the finish first, then the film line, then whether to wrap the whole van or only selected panels.

The factory paint under the wrap only matters for how clean it is on install day. Any chips should be touched up first so the film does not lock in rust. The door tracks are not covered, so the factory color shows there as a thin line. Seams are placed along panel edges where the film can be cut neatly, like the rear edge of the sliding doors.

The carbon fiber film is removable without special tools beyond a heat gun and patience. The van's panels pull the film taut, but the adhesive lets go when warmed evenly. Hand wash the wrapped Biante with a soft mitt and a mild soap, and avoid pressure washers on edges. No permanent change to the body means the wrap can be returned to factory paint later.