An M.Go wrapped in white starts with the finish you want the color to have. Matte and satin films cut reflections and make the 118.2 in (3,003 mm) body look softer. Gloss films keep the shine of factory paint and make white look brightest. The color change uses one film finish over the whole car, so the choice locks the effect.
Factory paint condition matters before any white film goes on the M.Go. This car stays small, but the two long side doors are each one large piece of film, so a clean surface keeps the wrap smooth. Seams run where panels meet, and the tailgate film ends at the edge of the rear glass. Any paint chip or scratch shows through a light color, so the paint gets fixed first.
A white wrap on the M.Go is removable when the film is intact and the paint was sound before the install. A hand wash with mild soap keeps dirt from building up along the edges of the doors. The tailgate seam around the glass needs the most attention because it is the most touched edge. No harsh chemicals or automatic brushes touch the film, and the wrap stays clean longer.


