Wraps by car

Morris Marina wrap

The Morris Marina wrap page covers the single generation built from 1971 to 1980 in coupe, sedan, and wagon body styles. A full vinyl wrap of the newest body takes about 44 ft (13.5 m) for the coupe to 51 ft (15.5 m) for the wagon using 60-inch (1.52 m) cast film. Add chrome or patterned film and the total can reach 66 ft (20 m).

1generations13.5 mof film for a full wrap

Morris Marina, first generation, factory photo
Morris Marina, first generation. Factory color shown.

Morris Marina wrap colors and ideas

  • Marina black wrap
  • Marina white wrap
  • Marina gray wrap
  • Marina silver wrap
  • Marina red wrap
  • Marina blue wrap
  • Marina green wrap
  • Marina yellow wrap
  • Marina orange wrap
  • Marina purple wrap
  • Marina pink wrap
  • Marina teal wrap
  • Marina brown wrap
  • Marina gold wrap
  • Marina chrome wrap
  • Marina color shift wrap
  • Marina carbon fiber wrap
  • Marina camo and patterned wrap

How much vinyl to wrap a Morris Marina

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1971–1980coupe, sedan, wagon (2 or 4 doors)163.1 in (4,143 mm) to 166.1 in (4,219 mm)about 44 ft (13.5 m) for the coupe to 51 ft (15.5 m) for the wagon, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 66 ft (20 m)

Marina wrap cost factors

Marina wrap cost depends on the body style, the film type, and the amount of disassembly, from about 44 ft (13.5 m) for the coupe to 51 ft (15.5 m) for the wagon. A chrome delete or patterned film adds material because the wrap can reach 66 ft (20 m) of film. Removing trim, bumpers, and door handles increases labor. A coupe with one installer will cost less than a wagon with many cut-outs.

  • Film for a full wrap: about 44 ft (13.5 m) for the coupe to 51 ft (15.5 m) for the wagon, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 66 ft (20 m).
  • Body: coupe, sedan, wagon (2 or 4 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Marina wraps by generation

Swipe sideways. Tap a card for the full description.

Morris Marina, first generation, factory photo
Factory color shown

1971–1980 Marina coupe, sedan, wagon (first generation)

1971–1980coupe, sedan, wagon (2 or 4 doors)163.1 in (4,143 mm) to 166.1 in (4,219 mm)

The body styles of the Morris Marina are the coupe, sedan, and wagon, each with 2 or 4 doors. The style decides the panel plan, so the coupe has a shorter roof and the wagon has a tall tailgate that needs careful glass trimming. Film amounts range from about 44 ft (13.5 m) for the coupe to 51 ft (15.5 m) for the wagon. The sedan sits between them and shares the same front doors.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 44 ft (13.5 m) for the coupe to 51 ft (15.5 m) for the wagon, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 66 ft (20 m).

Roof, hood, chrome delete and PPF on a Marina

A partial wrap on a Morris Marina covers the roof, hood, or mirror caps without wrapping the whole car. Marina chrome delete covers the window trim and badges with black film for a cleaner look. Paint protection film (PPF) is a clear film on the front end that guards against stone chips. These jobs use less material than a full wrap and can be done in stages.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Morris Marina: body, cut-outs and film

A Morris Marina vinyl wrap follows the compact body's simple coupe, sedan, and wagon shapes that measure between 163.1 in (4,143 mm) and 166.1 in (4,219 mm). The wagon uses the most film because of its tall tailgate and long roof. The sedan and coupe share similar side panels, so their film needs are close. The size means a full wrap is a manageable project for one installer.

Marina wrap ideas start with the tailgate, where the rear glass is set into the tailgate and the film ends neatly at the edge of the glass. Door handles, badges, and trim need cut-outs or removal for a clean finish. The wagon roof rails can be wrapped if they are smooth, but they add time. Chrome bumpers can be left bright or covered with black film for a chrome delete.

The single generation of the Morris Marina ran from 1971 to 1980, so how much vinyl to wrap a Marina depends on the body style, not the year. The coupe needs about 44 ft (13.5 m) and the wagon up to 51 ft (15.5 m) of 60-inch (1.52 m) film. Later cars had larger plastic bumpers that take a little extra film if you cover them. The panel count stays the same across all years.

Questions about wrapping a Morris Marina

How much vinyl does it take to wrap a Morris Marina?

A full wrap takes about 44 ft (13.5 m) of 60-inch (1.52 m) film for the coupe and up to 51 ft (15.5 m) for the wagon. Chrome or patterned film adds to the total, reaching about 66 ft (20 m). The estimate includes waste from trimming around the tailgate glass and panel overlaps.

Which Marina body takes more film?

The wagon takes more film than the coupe or sedan, up to 51 ft (15.5 m) compared to 44 ft (13.5 m) for the coupe. The wagon's tall tailgate and longer roof account for the extra material. The sedan sits between the two styles.

Can I wrap only the hood or the roof of a Marina?

Yes, you can wrap only the hood or the roof of a Marina as a partial wrap without doing the whole car. Mirror caps are another small job that changes the look quickly. For the roof, a 5 ft by 6 ft piece of film is enough on a coupe, and the wagon may need one foot more.

Is a Marina hard to wrap?

A Marina is not hard to wrap, but the tailgate with the rear glass set into it adds work because the film must end at the edge of the glass. The compact size from 163.1 in (4,143 mm) to 166.1 in (4,219 mm) keeps panel lengths short. Chrome trim and door handles need removal or careful cutting for a clean result.