Wraps by car

Morris Mini wrap

The Morris Mini wrap page covers the fourth-generation Morris Mini, produced from 1976 to 1983. This one-generation catalog focuses on the two-door hatchback body. A full vinyl wrap of this body takes about 34 ft (10.5 m) of 60-inch (1.52 m) cast film.

1generations10.5 mof film for a full wrap

Morris Mini, fourth generation, factory photo
Morris Mini, fourth generation. Factory color shown.

Morris Mini wrap colors and ideas

  • Mini black wrap
  • Mini white wrap
  • Mini gray wrap
  • Mini silver wrap
  • Mini red wrap
  • Mini blue wrap
  • Mini green wrap
  • Mini yellow wrap
  • Mini orange wrap
  • Mini purple wrap
  • Mini pink wrap
  • Mini teal wrap
  • Mini brown wrap
  • Mini gold wrap
  • Mini chrome wrap
  • Mini color shift wrap
  • Mini carbon fiber wrap
  • Mini camo and patterned wrap

How much vinyl to wrap a Morris Mini

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1976–1983hatchback (2 doors)120.2 in (3,054 mm)about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 44 ft (13.5 m)

Mini wrap cost factors

Mini wrap cost depends on the amount of film and the labor for this small hatchback. A full wrap of the Morris Mini needs about 34 ft (10.5 m) of cast film, with chrome or patterned film requiring about 44 ft (13.5 m). The two long doors and the tailgate with glass add time to the installation.

  • Film for a full wrap: about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 44 ft (13.5 m).
  • Body: hatchback (2 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Two long side doors: each door is one large piece of film.

Mini wraps by generation

Swipe sideways. Tap a card for the full description.

Morris Mini, fourth generation, factory photo
Factory color shown

1976–1983 Mini hatchback (fourth generation)

1976–1983hatchback (2 doors)120.2 in (3,054 mm)

The fourth-generation Morris Mini was built from 1976 to 1983, and its paint age matters before wrapping. On a car of these years panels may be original or repainted, so the surface condition varies. A test spot comes before a full wrap to check adhesion on old paint.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 44 ft (13.5 m).

Roof, hood, chrome delete and PPF on a Mini

Partial wrap options for the Morris Mini include the roof, hood, and mirror caps. Mini chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is clear film applied to the front end for protection.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Morris Mini: body, cut-outs and film

The Morris Mini vinyl wrap suits the two-door hatchback body, which is 120.2 in (3,054 mm) long. The short length keeps film use low for a full color change. Each long side door is one large piece of film, so the sides need wide, careful cuts.

Mini wrap ideas include working around the tailgate, where the film ends at the edge of the rear glass. The two long side doors are each wrapped as one large piece. This means a clean install needs long, uninterrupted film panels on both sides.

How much vinyl to wrap a Mini depends on the generation, and this page covers only the fourth generation. For the 1976–1983 Morris Mini, a full wrap uses about 34 ft (10.5 m) of standard cast film. If you choose chrome or patterned film, plan for about 44 ft (13.5 m) because of pattern matching.

Questions about wrapping a Morris Mini

How much vinyl does it take to wrap a Morris Mini?

A Morris Mini full wrap takes about 34 ft (10.5 m) of 60-inch (1.52 m) cast film. For chrome or patterned film, the estimate is about 44 ft (13.5 m). These figures are for the fourth-generation two-door hatchback.

Can I wrap only the hood or the roof of a Mini?

Yes, you can wrap only the hood or the roof of a Mini. Partial wrap jobs on this car include the roof, hood, and mirror caps. These smaller areas use less film than a full wrap.

Is a Mini hard to wrap?

A Mini is not the hardest car to wrap, but it has points that add work. The tailgate has the rear glass in it, so the film ends at the edge of the glass and needs a clean cut. The two long side doors each require one large piece of film, which demands careful handling.

How many generations of the Mini does this page cover?

This page covers one generation of the Morris Mini. It is the fourth generation, produced from 1976 to 1983. The body style is a two-door hatchback.