A Scenic wrapped in gray starts with choosing a finish, then a film, then full or partial color change. Matte gray hides fingerprints and softens the van's curves, while satin adds a slight sheen and gloss shows the deepest reflections. The fourth generation's sliding side doors leave the tracks bare, so the film is cut cleanly along them. The film estimate is about 67 ft (20.5 m) of 60-inch (1.52 m) cast film, and a partial wrap uses less.

The factory paint under a Scenic wrap is fully covered by the film, so color change makes the whole body one new gray. Seams are unavoidable on a longer panel, but a good installer places them at body lines and along the sliding door tracks. Some trims of the fourth generation have a panoramic glass roof, and the film ends at the roof rails because glass is not wrapped. Roof rails on those trims come off before the roof is wrapped, or the film is cut along them.

A gray wrap on the Scenic is removable and the film can be taken off without leaving adhesive on the paint. Hand wash the wrapped Scenic with a mild soap and a soft mitt to protect the edges and seams. Every trim has parking sensors in the bumpers, so the film is cut around each sensor and no water should be forced at those cuts. The wrap facts for the third generation note that bright decorative moldings on some trims stay bright next to the film unless a chrome delete covers them.