Wraps by car

Renault Wind wrap

The Renault Wind wrap is a vinyl wrap job on a subcompact two-door convertible built from 2010 to 2013, with just one generation in the catalog. A full color change wrap of the newest body uses about 41 ft (12.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film takes more material, roughly 46 ft (14 m).

1generations12.5 mof film for a full wrap

Renault Wind, first generation, factory photo
Renault Wind, first generation. Factory color shown.

Renault Wind wrap colors and ideas

  • Wind black wrap
  • Wind white wrap
  • Wind gray wrap
  • Wind silver wrap
  • Wind red wrap
  • Wind blue wrap
  • Wind green wrap
  • Wind yellow wrap
  • Wind orange wrap
  • Wind purple wrap
  • Wind pink wrap
  • Wind teal wrap
  • Wind brown wrap
  • Wind gold wrap
  • Wind chrome wrap
  • Wind color shift wrap
  • Wind carbon fiber wrap
  • Wind camo and patterned wrap

How much vinyl to wrap a Renault Wind

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2010–2013convertible (2 doors)150.9 in (3,833 mm)about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 46 ft (14 m)

Wind wrap cost factors

Wind wrap cost depends on the area wrapped, the film chosen, and the labor involved. A full wrap on this 150.9 in (3,833 mm) convertible uses about 41 ft (12.5 m) of 60-inch (1.52 m) cast film. Partial jobs like the hood or a chrome delete use less material but still require similar disassembly and finishing time.

  • Film for a full wrap: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 46 ft (14 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Wind wraps by generation

Swipe sideways. Tap a card for the full description.

Renault Wind, first generation, factory photo
Factory color shown

2010–2013 Wind convertible (first generation)

2010–2013convertible (2 doors)150.9 in (3,833 mm)

The open top of the Renault Wind is a fabric roof, and that fabric is not wrapped. The vinyl ends at the point where the roof meets the painted body panels. The area around the windshield header and the rear deck is taped and trimmed to follow the fabric edge cleanly.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 46 ft (14 m).

Roof, hood, chrome delete and PPF on a Wind

A partial wrap on the Renault Wind can cover the hood, mirror caps, or rear deck separately. A Wind chrome delete wraps the window trim and badges in black film. Paint protection film (PPF) as a clear film on the front end is another smaller job that leaves the rest of the paint bare.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Renault Wind: body, cut-outs and film

A Renault Wind vinyl wrap covers a small convertible body that is 150.9 in (3,833 mm) long. The short length and absence of rear doors keep the film need lower than on many larger cars. The two doors and the compact rear deck still require careful fitting around the fabric roof edges.

Wind wrap ideas usually start with accenting the hood, mirror caps, or rear deck, since these panels wrap cleanly. The fabric top is not wrapped, so the film must end neatly where the top meets the painted body. The window trim and badges can be covered in black film for a chrome delete.

How much vinyl to wrap a Wind depends on the film type and the installer's waste. With only one generation from 2010–2013, there are no body style changes to compare. The estimate of 41 ft (12.5 m) of 60-inch (1.52 m) cast film covers the painted surfaces without wrapping the fabric roof.

Questions about wrapping a Renault Wind

How much vinyl does it take to wrap a Renault Wind?

It takes about 41 ft (12.5 m) of 60-inch (1.52 m) cast film to wrap a Renault Wind. If the film is chrome or patterned, plan for about 46 ft (14 m) because of pattern matching and waste.

Is the top of a Wind wrapped?

No, the fabric top of a Renault Wind is not wrapped. The vinyl wrap ends where the fabric begins, so only the painted metal and plastic panels are covered.

Can I wrap only the hood or the roof of a Wind?

Yes, you can wrap only the hood, mirror caps, or rear deck of a Wind as a partial wrap. The hood and rear deck are the largest single panels, while the mirror caps are a quicker accent job.

Is a Wind hard to wrap?

A Renault Wind is moderately difficult to wrap because the fabric top edges require precise trimming. The car is only 150.9 in (3,833 mm) long, but the installer must work around the convertible top seals carefully.