Choosing a red FR-S wrapped in red starts with the finish: matte red is flat, satin red has a low sheen, and gloss red gives a deep shine. Next pick the film within that finish, since each brand supplies a different shade of red. Then decide between a full color change wrap and a partial job like the roof or hood. The long doors need careful installation because each panel is one large piece of film.

The factory paint on an FR-S from these years can be original or repainted, so a test spot is wise before the full wrap. Any damage hidden under the paint affects adhesion and may show through the vinyl. The film installers plan seams along panel edges so the red wrap looks clean. The coupe body is small enough that about 46 ft (14 m) of 60-inch (1.52 m) cast film covers it fully.

A red wrap on the FR-S is removable, leaving the paint underneath untouched when removal is done properly. Hand wash the wrapped car with a soft cloth and mild soap to keep the finish even. Avoid high-pressure sprays directly on the film edges. The wrap can be taken off later without leaving residue when the paint was in good condition.