A Crossover SX4 wrapped in red starts with a finish choice, then a film line inside that finish. A color change covers every outside panel, but you can also wrap only the roof, hood, or mirror caps. On this SUV the rear glass is inside the tailgate, so the installer cuts the film along the glass edge instead of wrapping glass. The film estimate for the newest body is about 56 ft (17 m) of 60-inch (1.52 m) cast film.

Factory paint condition decides how much preparation a Crossover SX4 wrap needs before the film goes on. Seams land at panel gaps and along the tailgate glass, where the installer trims the film cleanly. On some SX4 trims there are parking sensors and cameras, and the film is cut around each sensor and lens. The wrap still reads as one color because the seams follow the car's natural lines.

A red color change wrap on the Crossover SX4 is removable when the film is removed by hand. Use a hand wash with a soft mitt and a mild soap, and avoid automatic brushes that can lift an edge. On a daily-driven SX4, dirt shows faster along the lower doors and the tailgate where road spray hits. Hand washing also protects the cut edges around the tailgate glass and the sensors.