A Palette wrapped in carbon fiber film starts with the finish choice between carbon weave and forged carbon. Carbon weave shows a regular woven pattern, while forged carbon has an irregular, fragmented look. Then you choose a specific film and decide between a full color change or partial coverage. The sliding side door tracks stay bare, so the film is cut along them for a clean installation.

Factory paint condition decides the preparation work before the carbon fiber film goes on. The installer cleans the paint and may repair chips or scratches so the film lies flat. Seams on the Palette are planned around the sliding door tracks and body lines. A careful installer uses the tracks as natural seam locations to avoid lifting edges.

A carbon fiber wrap on the Palette is removable when the time comes to change the look. Quality cast film is designed to come off with heat and patience without leaving adhesive. Hand wash the wrapped vehicle with a soft sponge and mild soap. Avoid automatic car washes with brushes and do not aim a pressure washer at the edges.