A Tesla Model S wrapped in color shift film starts with the finish, because the finish decides how the color change reads on the long body. Matte and satin color shift films soften the reflections along the 195.7 in (4,970 mm) to 195.9 in (4,976 mm) length, while gloss films make the shift more vivid. Every finish here is a dry-apply film, so the installer can reposition it before pressure. The film is cut around the cameras and parking sensors on every trim.
Factory paint does not need to be perfect before the wrap, but every scratch shows through film, so the surface is cleaned and checked first. Seams are planned along the natural edges of the Tesla Model S, such as the tailgate glass edge and the roof rails. The tailgate lifts with the rear glass in it, so the film ends at the glass edge and no seam is placed across the glass. Each charge port door is wrapped as its own small piece, so the door opens without pulling the surrounding film.
The wrap is removable, which means the factory paint stays as it was when the film was applied. The car should be washed by hand because a pressure washer can lift an edge if it is aimed straight at a seam. After a hand wash, a microfiber drying towel works well on color shift film. The film should be kept clean, because dirt dulls the shift effect more than it dulls a plain color.

