A COMS wrapped in red starts with the finish, because it changes how the color reads on the body. Matte films give a flat, non-reflective red that hides small defects. Gloss films make the red deeper and closer to a fresh paint color change. The film choice then decides how much texture and sparkle the red shows.
Factory paint on the COMS is not always perfect, and every repainted panel needs a test spot before the full wrap. Seams on this body are few, because each long door is one piece of film. The charge port door is wrapped as its own small piece, so the electric port stays usable. This leaves a clean layout with minimal visible joins.
A red wrap on the COMS is removable, but removal is easier when the film was applied right and the paint was sound. Hand wash the wrapped body with a soft mitt and a mild car shampoo. Avoid automated brushes and pressure washers close to edges and seams. Good aftercare keeps the red even over every panel.


