Wraps by car

Toyota COMS wrap

This page covers the Toyota COMS wrap, a mini electric coupe produced from 2012 to the present. The catalog lists one generation of this car. A full vinyl wrap of the newest body takes about 28 ft (8.5 m) of 60-inch (1.52 m) cast film.

1generations8.5 mof film for a full wrap

Toyota COMS, first generation, factory photo
Toyota COMS, first generation. Factory color shown.

Toyota COMS wrap colors and ideas

  • COMS black wrap
  • COMS white wrap
  • COMS gray wrap
  • COMS silver wrap
  • COMS red wrap
  • COMS blue wrap
  • COMS green wrap
  • COMS yellow wrap
  • COMS orange wrap
  • COMS purple wrap
  • COMS pink wrap
  • COMS teal wrap
  • COMS brown wrap
  • COMS gold wrap
  • COMS chrome wrap
  • COMS color shift wrap
  • COMS carbon fiber wrap
  • COMS camo and patterned wrap

How much vinyl to wrap a Toyota COMS

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2012–nowcoupe (2 doors)94.3 in (2,395 mm)about 28 ft (8.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 33 ft (10 m)

COMS wrap cost factors

The COMS wrap cost depends mostly on how much film is used, and this mini car needs about 28 ft (8.5 m) of cast vinyl. The two long doors and the small body panels keep the material amount low compared to a larger car. The final cost also changes with the wrap type, such as a solid color, chrome, or patterned film needing about 33 ft (10 m).

  • Film for a full wrap: about 28 ft (8.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 33 ft (10 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.
  • Electric car: the charge port door is wrapped as a small piece of its own.

COMS wraps by generation

Swipe sideways. Tap a card for the full description.

Toyota COMS, first generation, factory photo
Factory color shown

2012–now COMS coupe (first generation)

2012–nowcoupe (2 doors)94.3 in (2,395 mm)

The first generation Toyota COMS has been produced since 2012 and is still the current body. On a car of these years, panels may be original paint or have been repainted at some point. A wrap shop will do a test spot on a panel before a full wrap to check how the film sticks to the aged or repainted surface.

Two long side doors: each door is one large piece of film.

Electric car: the charge port door is wrapped as a small piece of its own.

Film: about 28 ft (8.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 33 ft (10 m).

Roof, hood, chrome delete and PPF on a COMS

A partial wrap on a Toyota COMS can cover the roof, the hood, or the mirror caps for a smaller color change. COMS chrome delete covers the window trim and badges with black film instead of the original bright finish. Paint protection film (PPF) is a clear film applied to the front end to guard the paint from stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Toyota COMS: body, cut-outs and film

The Toyota COMS vinyl wrap needs to account for the car’s very small coupe body with two long side doors. Each door is one large piece of film, so the panel is easier to cover in a single sheet. The overall length of 94.3 in (2,395 mm) keeps material use low compared to full-size cars.

COMS wrap ideas start with the two side doors, which are the main flat panels to cover in one piece each. The electric charge port door is wrapped as a small separate piece so it can open normally after the install. You can plan cut-outs only around the door handles, mirrors, and charge port flap.

How much vinyl to wrap a COMS depends on the single generation since 2012, so the estimate stays the same for all production years. You will need about 28 ft (8.5 m) of 60-inch (1.52 m) cast film for a solid color change wrap. If you choose chrome or patterned film, the figure rises to about 33 ft (10 m) because the pattern must be matched.

Questions about wrapping a Toyota COMS

How much vinyl does it take to wrap a Toyota COMS?

A full wrap of a Toyota COMS takes about 28 ft (8.5 m) of 60-inch (1.52 m) cast vinyl film. If you use chrome or patterned film, you need about 33 ft (10 m) because the pattern must line up across panels.

Can I wrap only the hood or the roof of a COMS?

Yes, you can wrap only the hood or the roof of a COMS. A partial wrap on this car often covers the roof, the hood, or the mirror caps, while a chrome delete changes the window trim and badges to black.

Is a COMS hard to wrap?

The COMS is not hard to wrap compared to larger cars, but some details add work. Each of the two long side doors is one large piece of film, and the electric charge port door must be wrapped as a separate small piece so it still opens.

How many generations of the COMS does this page cover?

This page covers one generation of the Toyota COMS, the first and current generation produced from 2012 to now.