An Xpeng G3i wrapped in green starts with the finish that matches your vision for the color change. Matte film hides fingerprints and softens reflections on a car that sits high off the ground. Satin splits the difference between gloss and matte, with a low sheen that suits the G3i's hatchback proportions. Gloss film reflects the most light and makes the green read as a deeper, wetter color on the SUV's large side panels.
Factory paint under a wrap means the original color stays protected, and seams fall where the body design hides them. The G3i's tall doors and the panel behind the rear side window are wide enough that you see a seam only at the edge. A seam at the tailgate follows the glass line, so the film ends cleanly at the rear window. The installer plans seams around the charge port door, leaving it as the only small separate piece on this body.
Green wrap on the Xpeng G3i is removable, which makes it a reversible way to change the color. Hand wash the film to protect the edges from lifting, since pressure washers can force water under a seam. A pH-neutral soap and a soft mitt are enough for normal dirt, and you avoid brushes that scratch the surface. If the car was ceramic coated over the wrap, cleaning takes less effort because dirt does not cling as much.


