A Zenvo ST1 wrapped in green starts with choosing a matte, satin, or gloss finish that changes how light reflects off the body. The color change then depends on the specific film's tone and the installer's skill. Matte finishes absorb light and hide waves, while gloss finishes add depth similar to a fresh paint job. A full wrap covers the body and leaves the door jambs in the original color unless you pay extra to wrap those.

Factory paint on the Zenvo ST1 stays untouched under a wrap, which prevents UV rays and small stone chips from reaching the clear coat. Seams are placed along panel edges and body lines where the film naturally ends. On this coupe the two long side doors allow each door to be wrapped in one large piece, reducing visible seams. Badly aligned seams at the mirrors or door handles signal a rushed installation.

A removable color change wrap on the Zenvo ST1 can be taken off without leaving adhesive on the original paint when removed by a trained installer. Hand wash is the safest way to clean a wrapped car because pressure washers and automated brushes can lift the film edges. Use a soft sponge and a pH-neutral car shampoo, and rinse with low water pressure. Avoid wax or polish on matte or satin finishes because they create shiny spots that cannot be removed.