Wrapping a BYD F3 in camo or patterned film changes the color and adds a finish with a directional or repeating design. On the second generation, the 179.8 in (4,568 mm) sedan body leaves no sharp body lines that interrupt the pattern, but the front fog lamps require cut-outs in the bumper film. If the car has a sunroof, the roof film is cut around its opening. This color change is reversible, so the factory paint stays underneath.
Factory paint on an older BYD F3 can be original or repainted, and that affects how the film sticks. The second generation runs from 2012 to 2021, so each panel needs a test spot to check paint adhesion before the full wrap. Seams are placed at panel edges and along the door jambs, where a patterned film can be lined up across the gap. On a car with mixed paint, the installer may need to clean and prep each panel separately.
Camo and patterned film on a BYD F3 is removable, but the removal process depends on the paint condition underneath. A hand wash with mild soap keeps the edges from lifting, and pressure washing should be avoided near seams and cut-outs. If the film was applied over weak or flaking paint, removing it can pull paint with it. The wrap does not become permanent, but older paint needs careful removal.



