Planning an ATS-V wrapped in gray starts with choosing the finish, because every film line has its own gray shade. A color change wrap is one film applied over the factory paint, so the final look depends on the film and the installer's work. After the finish, pick a film from a line that suits the look you want and the shop's experience with it. Decide whether to cover the whole body or only selected panels, because that changes the amount of film and the labor.

The Cadillac ATS-V body has sharp creases and aggressive rear fenders that make film placement and seams important. Factory paint is the base for the wrap, so it must be clean and free of chips for the film to lay flat. Seams are placed along panel edges and body lines, and a good installer plans them before cutting the film. On the coupe the long doors need a wide film piece, while the sedan's rear door and quarter panel need careful alignment.

A gray wrap on the ATS-V is removable, so the original paint stays protected underneath. Hand wash the car with mild soap and a soft mitt, and avoid automatic car washes with brushes. Do not use a pressure washer close to film edges, because it can lift the film. Removing the wrap later is a job for a shop, because heat and the right technique keep the paint intact.