Wraps by car

Donkervoort S8A wrap

The Donkervoort S8A wrap page covers the first generation (1985–1993) of this convertible sports car. A vinyl wrap on this body takes about 34 ft (10.5 m) of 60-inch (1.52 m) cast film. For chrome or patterned film, plan on about 39 ft (12 m).

1generations10.5 mof film for a full wrap

Donkervoort S8A, first generation, factory photo
Donkervoort S8A, first generation. Factory color shown.

Donkervoort S8A wrap colors and ideas

  • Donkervoort S8A black wrap
  • Donkervoort S8A white wrap
  • Donkervoort S8A gray wrap
  • Donkervoort S8A silver wrap
  • Donkervoort S8A red wrap
  • Donkervoort S8A blue wrap
  • Donkervoort S8A green wrap
  • Donkervoort S8A yellow wrap
  • Donkervoort S8A orange wrap
  • Donkervoort S8A purple wrap
  • Donkervoort S8A pink wrap
  • Donkervoort S8A teal wrap
  • Donkervoort S8A brown wrap
  • Donkervoort S8A gold wrap
  • Donkervoort S8A chrome wrap
  • Donkervoort S8A color shift wrap
  • Donkervoort S8A carbon fiber wrap
  • Donkervoort S8A camo and patterned wrap

How much vinyl to wrap a Donkervoort S8A

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1985–1993convertible (2 doors)141.7 in (3,600 mm)about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 39 ft (12 m)

Donkervoort S8A wrap cost factors

A Donkervoort S8A wrap cost depends on the film chosen and the labor of covering a 141.7-inch body with many small panels. A color change on a car this size takes close to 34 ft of cast film, while chrome or patterned film raises the material amount to about 39 ft. Removal of mirrors, handles and badges adds time but gives a cleaner result.

  • Film for a full wrap: about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 39 ft (12 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Donkervoort S8A wraps by generation

Swipe sideways. Tap a card for the full description.

Donkervoort S8A, first generation, factory photo
Factory color shown

1985–1993 Donkervoort S8A convertible (first generation)

1985–1993convertible (2 doors)141.7 in (3,600 mm)

The first generation Donkervoort S8A has a convertible top that is not covered by vinyl wrap. The film ends at the body line where the fabric top meets the cockpit, so installers plan a clean edge there. A folding hard top, if fitted, is wrapped as its own separate panels.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 39 ft (12 m).

Roof, hood, chrome delete and PPF on a Donkervoort S8A

On the Donkervoort S8A, a partial wrap can cover the hood, mirror caps, or rear deck. A chrome delete turns the window trim and badges black with the same film. Paint protection film (PPF) on the front end is a clear option for stone chip coverage.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Donkervoort S8A: body, cut-outs and film

A Donkervoort S8A vinyl wrap follows the convertible body, which is 141.7 in (3,600 mm) long. The two-door shape has no separate roof, so film stops at the beltline where the folding top begins. The short rear deck and low nose keep panel count manageable.

Donkervoort S8A wrap ideas often start with deciding how to treat the open top. The fabric top is never wrapped, and film ends cleanly where it meets the body. Any folding hard top is wrapped as separate panels of its own.

To know how much vinyl to wrap a Donkervoort S8A, use the full-body estimate of about 34 ft (10.5 m) for 60-inch film. This single generation has only one convertible style, so the figure stays the same for all years from 1985 to 1993. If you choose chrome or patterned film, add about five feet to that estimate.

Questions about wrapping a Donkervoort S8A

How much vinyl does it take to wrap a Donkervoort S8A?

It takes about 34 ft (10.5 m) of 60-inch (1.52 m) cast film to fully wrap a Donkervoort S8A. For chrome or patterned film, the estimate rises to about 39 ft (12 m). This covers the entire convertible body of the first generation.

Is the top of a Donkervoort S8A wrapped?

The top of a Donkervoort S8A is not wrapped when it is a fabric convertible top. Film stops at the body line where the top begins. A folding hard top, if present, is wrapped as its own panels.

Can I wrap only the hood or the roof of a Donkervoort S8A?

You can wrap only the hood or the rear deck of a Donkervoort S8A as a partial job. The roof is not available as a wrapped panel because the car has a fabric top. Mirror caps and a front-end paint protection film are also common partial choices.

Is a Donkervoort S8A hard to wrap?

A Donkervoort S8A is moderately hard to wrap because of its small 141.7-inch body and the convertible top boundary. The fabric top requires a clean stopping line, and the folding hard top, if fitted, adds extra panels. Its compact curves need careful stretching of the cast film.