A Ferrari F12 Berlinetta wrapped in red starts with a finish choice between matte, satin and gloss, because each finish changes how the red reads on this body. The next decision is the film line, and the page lists 226 films from 17 brands for this color. A full color change wrap covers every painted panel, while a partial wrap leaves some body color showing. On this car the two long side doors are each covered with one large piece of film, so the installer needs a clean, long stretch of film.
Factory paint condition matters before a red wrap on the F12 Berlinetta, because film shows the texture of the surface under it. Any stone chip, scratch or old touch-up will be visible through gloss film, and matte film hides less than you might expect. The wrap itself has seams where film panels meet, and on this body the main seams run along the roof edges and the door shut lines. A good installer plans those seams so they sit on body lines, not across a flat panel.
A red wrap on the F12 Berlinetta is removable, so the original paint comes back when the film is taken off. Removal is cleanest when the film is removed by a shop that knows the material and the paint underneath. After the wrap is on, hand wash the car with a soft mitt and a mild soap, and avoid automatic car washes with brushes. That keeps the edges of the film down and the red color even.


