An F12 Berlinetta wrapped in carbon fiber film starts with the finish decision, not the brand. Forged carbon has a random, crushed pattern while weave runs in straight lines. A weave film on this car’s long doors shows the direction clearly, so the installer must keep it consistent from panel to panel. The finish you pick also changes how the wrap looks in direct sun.

The F12 Berlinetta’s factory paint condition shapes how the carbon fiber film sits at the panel edges. Every trim has fog lamps in the front bumper, so the bumper film needs clean cut-outs around them. The two long side doors are each covered with one large piece of film, which calls for careful positioning. A full color change wrap stops at the door jambs unless you specify otherwise.

A carbon fiber wrap on the F12 Berlinetta is removable, so it protects the original paint underneath. The film lifts with heat and leaves the factory finish untouched when the paint was intact before wrapping. Hand wash the car after the wrap and avoid high-pressure jets near the film edges. The fog lamp cut-outs are the spots where lifted film starts on this car.