Wrapping a Haima M3 in carbon fiber film starts with the finish: a regular carbon weave or a forged carbon look. The weave has a visible repeating fiber pattern while forged carbon shows a broken, non-repeating texture. Both finishes are available in black and with a gloss or matte face. The decision between them changes how light falls on the sedan's panels.
Factory paint condition matters before you wrap the Haima M3: carbon film hides little, so deep chips and rust should be fixed first. On the sedan body the film is applied panel by panel, and seams are placed at natural shut lines and edges. The hood on the M3 is large, and a good installer will use one piece for it. This keeps the carbon pattern straight and avoids a seam down the middle.
Carbon fiber film is removable, so returning a leased or financed Haima M3 to factory paint is possible. Hand wash the wrapped car and avoid high-pressure water at film edges, especially around the sedan's door handles. The bumpers and sills are the areas to check after a wash. A small lift at an edge can be pressed back down if the film is warm.

