Order the decisions for a Hongqi HS7 wrapped in chrome by finish first, then film line, then full or partial coverage. Standard cast chrome in silver or black gives a clean mirror look and is the film type our measurements assume. Brushed, satin or prismatic chrome changes the reflection and the way light moves over the tall panels. After the finish, pick a film line with the width and roll length that suits your installer.

Factory paint must be fully cured and defect-free before chrome vinyl goes on. On a color change, any chip, scratch or rough spot shows through as a dot or line in the reflection. The flat sides of the HS7 gently curve, so one piece of film can often cover a whole door with no seam in the middle. Seams are planned at the sharp body lines and at the base of the pillars, not in the middle of a panel.

Chrome film is removable but it must be pulled with heat from one corner, never ripped off. The adhesive releases cleanly and leaves the original paint, as long as the paint was healthy when the wrap went on. Hand wash only: automatic brushes scratch the surface of the chrome and leave bright marks that cannot be polished out. Use a soft mitt, pH-neutral shampoo and plenty of water.