A Jaguar XFR wrapped in camo or patterned film starts with the finish, then the film brand, then the coverage. Honeycomb reads as a technical, almost motorsport look, while brushed metal looks more like an industrial color change. The pattern must run one way and line up across panels, so the installer needs extra film to match it at the tailgate and around the rear glass. Some trims have parking sensors in the bumpers, so the film is cut around each sensor rather than over it.

Factory paint still matters under a patterned wrap because the pattern does not hide deep scratches or chips. The XFR's tailgate carries the rear glass in it, so the film ends at the edge of the glass and a long horizontal seam can appear there on the wagon. On the sedan, the trunk lid is a single large panel that makes the pattern easier to center. The restyling in 2011 changed the bumpers and lights, so a film kit cut for one version will not fit the other.

The wrap is removable, so the factory paint is not permanently changed by a camo or patterned film. A clean removal depends on proper surface preparation and on not leaving the film on past its service life. Wash a wrapped XFR by hand with a mild soap and a soft mitt, because high-pressure water can lift the edges at the sensors or the tailgate glass. Avoid automatic car washes with brushes, which can catch the pattern edges and peel the film.