A Mazda 6 wrapped in camo or patterned film starts with the finish choice, because each pattern reads differently on the body. Then you pick the film itself from the group that matches the finish. Finally you decide between a full wrap and a partial wrap like a roof or hood. The third generation has a tailgate with the rear glass in it, so the film ends at the edge of the glass on the wagon.

Factory paint on the Mazda 6 affects no part of the film choice, but it must be clean and smooth before install. Seams are planned where the film ends, such as at the edge of the rear glass on the tailgate. Some trims have parking sensors or cameras, and the film is cut around each sensor or lens. These cut-outs ask for a careful hand, but they do not limit the patterns you can use.

Camo and patterned wrap film is removable, so you can return the Mazda 6 to its factory paint later. A hand wash with a soft mitt and mild soap keeps the pattern clean and the edges down. Avoid automatic car washes with brushes, because they can lift the film at the cut-outs. The film needs no wax or polish, only rinsing and drying.