A McLaren 765LT wrapped in camo or patterned film starts with three decisions in order: finish first, then film line, then how much of the body is covered. The finishes on this page are camouflage, brushed metal, and snakeskin or honeycomb, and each changes how the light falls across the car's tall body of 85.1 in (2,161 mm). Pick a finish before comparing film brands because a brushed metal reads as a color change from a distance while a true camouflage pattern breaks up the shape. You then decide between a full wrap and a partial wrap such as the roof or hood.

Factory paint stays important under a camo and patterned wrap because film is translucent enough to show deep chips or peeling clear coat through the finish. The two long side doors of the 765LT each go on as one large piece of film, and a good installer plans where the pattern meets at the edges to avoid busy seams. Seams are placed along body lines and shut lines, so on a coupe the roof can be one long panel while the convertible ends the film where its top begins. The film estimate for the coupe is about 62 ft (19 m) of 60-inch (1.52 m) cast film.

The wrap is removable, and on the McLaren 765LT you hand wash it with a soft mitt and pH-neutral soap to avoid lifting the edges. A pressure washer is fine at low pressure from a distance, but keep the nozzle away from the film edges and the convertible top seals. The two long side doors mean water runs along the film to the sills, so dry those areas after washing. Never use wax or abrasive polish on a camo and patterned wrap because it dulls the finish.