A Polestar 1 wrapped in carbon fiber film starts with a finish choice between carbon weave and forged carbon. Carbon weave is a regular crosshatch fabric pattern, and forged carbon has a busy marbled look. On this coupe the finish reads strongly on the long side doors, so view both in person before choosing. The film you pick then determines how the color change is installed and maintained.
Factory paint must be washed, clayed and wiped with isopropyl alcohol before film, or it will lift at the edges. The Polestar 1 has deep door jambs, which means seams can be hidden well behind the long doors. Seams on this coupe run along the roof rails and around the bumpers, where the film cannot stretch over one piece. A good installer plans seams so they follow the body lines and stay out of sight.
The film is removable when it is warmed and peeled slowly by hand, and it leaves the paint underneath. After the wrap, use a hand wash with a soft sponge and a pH-neutral soap. Do not use a pressure washer or automatic car wash, because they can lift edges and cut the film.

