A Polestar 1 wrapped in green starts as a color change over the factory paint. Choose the finish first because it changes the look more than the shade. Then pick a film line that matches how you use the car. A full wrap covers the paint, but partial wraps can change only some panels.
The factory paint stays under the wrap and is protected from light wear. Seams are needed where film meets a panel edge or a tight curve. The two long side doors each take one large piece of film. This leaves fewer seams than on a four-door car.
A green wrap is removable when it is time to sell the car or change the color. Hand wash the Polestar 1 to keep the film edges down. A pressure washer can lift film if it is aimed at a seam. Use a mild soap and a soft mitt.


