A Radar RD6 wrapped in white is a full color change over the factory paint. The finish sets the look before a single panel is cut: matte is flat, satin has a slight sheen, and gloss reflects like clear coat. The film choice follows from that, because each finish group on this page has its own films. Full or partial wrap is the third call, and a partial wrap still changes the look with less film.
Factory paint shows only at the door jambs and the inside of the bed on this pickup. Every wrapped panel has seams at its edges, so the installer must plan them around the body lines. The bed and the cab are separate surfaces, which means more seams than on a one-piece body. A clean install keeps the seams tight and the edges tucked.
A white wrap is removable, so the factory paint is protected underneath. Hand wash the RD6 after wrapping and skip the pressure washer on the edges. Use a soft mitt and pH-neutral soap to keep the film clean. This care keeps the finish even across the cab and the bed.


