Wraps by car

SsangYong Kallista wrap

The SsangYong Kallista wrap page covers the single-generation convertible built from 1992 to 1994. A full vinyl wrap of the newest body takes about 41 ft (12.5 m) of 60-inch (1.52 m) cast film. The car is a compact two-door sports car with a body length of 151.7 in (3,854 mm).

1generations12.5 mof film for a full wrap

SsangYong Kallista, first generation, factory photo
SsangYong Kallista, first generation. Factory color shown.

SsangYong Kallista wrap colors and ideas

  • Kallista black wrap
  • Kallista white wrap
  • Kallista gray wrap
  • Kallista silver wrap
  • Kallista red wrap
  • Kallista blue wrap
  • Kallista green wrap
  • Kallista yellow wrap
  • Kallista orange wrap
  • Kallista purple wrap
  • Kallista pink wrap
  • Kallista teal wrap
  • Kallista brown wrap
  • Kallista gold wrap
  • Kallista chrome wrap
  • Kallista color shift wrap
  • Kallista carbon fiber wrap
  • Kallista camo and patterned wrap

How much vinyl to wrap a SsangYong Kallista

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1992–1994convertible (2 doors)151.7 in (3,854 mm)about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 46 ft (14 m)

Kallista wrap cost factors

Kallista wrap cost depends on the condition of the body and how much of the car is covered. A full color change on this 1992–1994 convertible uses about 41 ft (12.5 m) of film, while a partial job uses less. The cost also changes with the film you pick: a solid color, a chrome or patterned film needs about 46 ft (14 m). The work of trimming around the convertible top and the few panels adds time.

  • Film for a full wrap: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 46 ft (14 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Kallista wraps by generation

Swipe sideways. Tap a card for the full description.

SsangYong Kallista, first generation, factory photo
Factory color shown

1992–1994 Kallista convertible (first generation)

1992–1994convertible (2 doors)151.7 in (3,854 mm)

The first generation SsangYong Kallista is an open two-door convertible with a fabric top that is not wrapped. The vinyl ends where the painted metal meets the top seals, so the film does not climb onto the fabric. If the car has a folding hard top, that part is wrapped as separate panels of its own. An installer stops the film at the top of the doors and rear quarters for a clean edge.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 46 ft (14 m).

Roof, hood, chrome delete and PPF on a Kallista

For this car, a partial wrap most often covers the hood, mirror caps and rear deck. A chrome delete on a SsangYong Kallista means covering the window trim and badges with black film. Paint protection film (PPF) is a clear film that goes on the front end to guard against stone chips. These smaller jobs use less vinyl than a full wrap and still change the look of the car.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a SsangYong Kallista: body, cut-outs and film

A SsangYong Kallista vinyl wrap has to follow the lines of one body style only, a two-door convertible. Because the car is short at 151.7 in (3,854 mm), every panel is within easy reach of a standard 60-inch (1.52 m) roll. The open body means the film ends at the top of the doors and rear quarters, not at a roof. Installers can wrap the whole shell with less waste than on a fixed-roof coupe.

Kallista wrap ideas start with the parts of a convertible that stay painted. The hood, front fenders, doors and rear deck are the main vinyl surfaces. Around the windshield and side glass, the film is trimmed tight to the rubber seals. Door handles and mirrors are removed or wrapped as separate pieces for clean edges.

If you count how much vinyl to wrap a Kallista, the single generation makes the math simple. The catalog lists only the 1992–1994 convertible, so the film estimate does not change between model years. The body is 151.7 in (3,854 mm) long, and a full wrap uses about 41 ft (12.5 m) of 60-inch (1.52 m) film. That figure covers the painted shell, not the fabric top.

Questions about wrapping a SsangYong Kallista

How much vinyl does it take to wrap a SsangYong Kallista?

It takes about 41 ft (12.5 m) of 60-inch (1.52 m) cast film to wrap a SsangYong Kallista. That figure is for the newest body in the catalog, the 1992–1994 convertible. If you choose a chrome or patterned film, count on about 46 ft (14 m). The fabric top is not wrapped, so the estimate covers the painted shell only.

Is the top of a Kallista wrapped?

No, the fabric top of a Kallista is not wrapped. The film ends where the painted metal meets the top seals. Only a folding hard top would be wrapped as its own panels.

Can I wrap only the hood or the roof of a Kallista?

Yes, you can wrap only the hood or the rear deck of a Kallista. A partial wrap on this car often covers the hood, mirror caps and rear deck. The roof is fabric and is not wrapped.

Is a Kallista hard to wrap?

A Kallista is not hard to wrap, but the convertible body adds trim work. The fabric top is left unwrapped, so the film must end cleanly along the top of the doors and rear quarters. At 151.7 in (3,854 mm) long, the car is small enough for one installer to manage the panels. The door handles and mirrors are removed or wrapped separately for a tidy finish.