An Avanza wrapped in green starts with the finish, since matte, satin, gloss and metallic each change how the color reads on the tall van body. The color change film then follows the body lines, with the sliding door tracks left bare and the film cut along them. For an even look, order film for the full van, not just the large side panels, because the roof and pillars add area.

Factory paint on the Avanza is the base for the wrap, and any chip or scratch will show through the film as a small mark. Seams are planned where panels meet, so a clean surface and good panel gaps make the seams less visible. On a minivan the door shuts and the lower sills collect dirt, so clean those areas well before the film goes on.

A green wrap on the Avanza is removable, and when removed correctly it leaves the factory paint as it was. Hand wash the wrapped van with a soft mitt and a mild soap, and avoid automatic brushes that can lift an edge. The sliding door tracks should stay free of soap and wax so the film edge does not peel there.