Wraps by car

Toyota Avanza wrap

The Toyota Avanza wrap is a full color change for a compact minivan sold across two generations. This page covers the second generation from 2011 to 2015 and the first generation from 2006 to 2011. A full wrap of the newest body takes about 59 ft (18 m) of 60-inch (1.52 m) cast vinyl film.

2generations18 mof film for a full wrap

Toyota Avanza, second generation, factory photo
Toyota Avanza, second generation. Factory color shown.

Toyota Avanza wrap colors and ideas

  • Avanza black wrap
  • Avanza white wrap
  • Avanza gray wrap
  • Avanza silver wrap
  • Avanza red wrap
  • Avanza blue wrap
  • Avanza green wrap
  • Avanza yellow wrap
  • Avanza orange wrap
  • Avanza purple wrap
  • Avanza pink wrap
  • Avanza teal wrap
  • Avanza brown wrap
  • Avanza gold wrap
  • Avanza chrome wrap
  • Avanza color shift wrap
  • Avanza carbon fiber wrap
  • Avanza camo and patterned wrap

How much vinyl to wrap a Toyota Avanza

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2011–2015van (5 doors)163.0 in (4,140 mm)about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m)
2006–2011van (5 doors)162.2 in (4,120 mm)about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m)

Avanza wrap cost factors

Avanza wrap cost depends on the size of the van and the condition of its paint. Both generations are about 163 in (4,140 mm) long, so a full wrap uses roughly 59 ft (18 m) of film, or more with a pattern. Older cars may need paint correction before the film goes on. Removing and refitting parts like door handles and roof rails adds labor.

  • Film for a full wrap: about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.

Avanza wraps by generation

Swipe sideways. Tap a card for the full description.

Toyota Avanza, second generation, factory photo
Factory color shown

2011–2015 Avanza van (second generation)

2011–2015van (5 doors)163.0 in (4,140 mm)

The second generation Toyota Avanza has sliding side doors, and the door tracks stay bare. A wrap installer cuts the film along the tracks so the doors can still open without dragging. That edge is the main detail a viewer sees on the side of the van. Taking the tracks into account before cutting keeps the wrap from lifting.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Film: about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).

Toyota Avanza, first generation, factory photo
Factory color shown

2006–2011 Avanza van (first generation)

2006–2011van (5 doors)162.2 in (4,120 mm)

The first generation Toyota Avanza was built from 2006 to 2011, so paint age is a real concern before wrapping. Some panels may have been repainted, and a test spot on the paint shows whether the film will bond well. A full wrap is still possible on an older van after the paint is checked. The sliding side doors also need the film cut along the bare door tracks.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Film: about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).

Roof, hood, chrome delete and PPF on an Avanza

A partial wrap on a Toyota Avanza can be a roof, a hood, or mirror caps. Avanza chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is a clear film applied to the front end. These jobs use less film than a full wrap and can be done in stages.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Toyota Avanza: body, cut-outs and film

The Toyota Avanza vinyl wrap covers one body style: a five-door van. The newest body is 163.0 in (4,140 mm) long and the older one is 162.2 in (4,120 mm), so both need roughly the same amount of film. That compact length keeps the job close to a small hatchback. A wrap installer can reach every panel without special lifts.

Avanza wrap ideas start with the sliding side doors, because the door tracks stay bare and the film is cut along them. Badges, door handles, and mirrors are removed or cut around, depending on the design. The roof rails and rear spoiler, when fitted, add a few small pieces. Precise trimming around the sliding door tracks is what gives a clean finish.

How much vinyl to wrap an Avanza depends on the generation, but the difference is tiny. The 2011–2015 van is 0.8 in (20 mm) longer than the 2006–2011 van, which does not change the film estimate. Both generations use the same five-door van body, so a shop counts the same panels. The larger change is whether you choose chrome or patterned film, which raises the estimate to about 70 ft (21.5 m).

Questions about wrapping a Toyota Avanza

How much vinyl does it take to wrap a Toyota Avanza?

No, a full wrap of a Toyota Avanza takes about 59 ft (18 m) of 60-inch (1.52 m) cast film, but a chrome or patterned film raises the estimate to about 70 ft (21.5 m). The van is small enough that the extra film is only for waste from pattern matching. Both generations use the same estimate because the bodies are nearly identical.

Are the sliding doors of an Avanza wrapped?

Yes, the sliding doors of an Avanza are wrapped, but the door tracks stay bare. The film is cut along the tracks so the doors can open and close without catching. That cut line is part of the wrap design on both generations.

Can I wrap only the hood or the roof of an Avanza?

Yes, you can wrap only the hood or the roof of an Avanza as a partial wrap. A shop also offers chrome delete for window trim and badges, and clear paint protection film for the front end. A partial job uses less film than a full wrap and can be combined with other small changes.

Is an Avanza hard to wrap?

An Avanza is not hard to wrap, but the sliding side doors add work. The door tracks stay bare and the film must be cut along them on both generations. The van is only about 163 in (4,140 mm) long, so there are no oversized panels. Good planning around the tracks makes the job straightforward.