Wraps by car

Borgward Arabella wrap

The Borgward Arabella wrap page covers the first and only generation of the compact two-door sedan built from 1959 to 1963. A full vinyl wrap of this small car takes about 41 ft (12.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, plan for about 52 ft (16 m) to cover the bright trim and body. The Arabella's modest size makes it a manageable project for a careful wrapper.

1generations12.5 mof film for a full wrap

Borgward Arabella, first generation, factory photo
Borgward Arabella, first generation. Factory color shown.

Borgward Arabella wrap colors and ideas

  • Arabella black wrap
  • Arabella white wrap
  • Arabella gray wrap
  • Arabella silver wrap
  • Arabella red wrap
  • Arabella blue wrap
  • Arabella green wrap
  • Arabella yellow wrap
  • Arabella orange wrap
  • Arabella purple wrap
  • Arabella pink wrap
  • Arabella teal wrap
  • Arabella brown wrap
  • Arabella gold wrap
  • Arabella chrome wrap
  • Arabella color shift wrap
  • Arabella carbon fiber wrap
  • Arabella camo and patterned wrap

How much vinyl to wrap a Borgward Arabella

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1959–1963sedan (2 doors)150.8 in (3,830 mm)about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m)

Arabella wrap cost factors

The Arabella wrap cost depends on the film type, the amount of disassembly, and the condition of the paint on this 1959–1963 sedan. A full wrap needs about 41 ft (12.5 m) of 60-inch (1.52 m) cast film, while chrome or patterned film takes about 52 ft (16 m). Preparing old paint and removing trim for a clean install adds labor time to the job. A shop will also charge for cut-outs around the grille, taillights, and window trim because those areas need extra care.

  • Film for a full wrap: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).
  • Body: sedan (2 doors).
  • Two long side doors: each door is one large piece of film.

Arabella wraps by generation

Swipe sideways. Tap a card for the full description.

Borgward Arabella, first generation, factory photo
Factory color shown

1959–1963 Arabella sedan (first generation)

1959–1963sedan (2 doors)150.8 in (3,830 mm)

The first generation Borgward Arabella was built from 1959 to 1963 as a compact two-door sedan. Paint age matters on a car of these years: panels may be original or repainted, and a test spot comes before a full wrap. Old paint that is cracked or lifting will not hold film well, so the surface often needs sanding and priming first. The wrapper should check each panel before cutting film to avoid lifting later.

Two long side doors: each door is one large piece of film.

Film: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).

Roof, hood, chrome delete and PPF on an Arabella

A partial wrap on the Arabella can cover just the roof, hood, or mirror caps for a smaller job. Arabella chrome delete covers the window trim and badges with black film to change the brightwork. Clear paint protection film (PPF) can be applied to the front end to shield the hood, fenders, and grille from stone chips. All of these options use less film than a full color change wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Borgward Arabella: body, cut-outs and film

The Borgward Arabella vinyl wrap starts with a body that is compact and short at 150.8 in (3,830 mm). Its two long side doors are each one large piece of film, so each door can be wrapped in a single pass without seams. The sedan's low roof and simple surfaces keep film use efficient, with little waste on deep curves or wide bumpers. This body shape means the full wrap figure of about 41 ft (12.5 m) is realistic for most film patterns.

Arabella wrap ideas include color change wraps that follow the sedan's clean, simple lines. The two long side doors are the main flat areas, each done as one large piece of film. For chrome or patterned film, the bright window trim and badges take extra length, about 52 ft (16 m) total. The front grille and taillight housings need careful cut-outs because the chrome is part of the body's character.

How much vinyl to wrap an Arabella depends on the single generation covered here, produced 1959–1963. No body changes between years affect the film estimate, since the catalog includes only the first generation. Every Arabella in this range is the same two-door sedan at 150.8 in (3,830 mm) long. The same 41 ft (12.5 m) of 60-inch (1.52 m) film applies to all cars from these production years.

Questions about wrapping a Borgward Arabella

How much vinyl does it take to wrap a Borgward Arabella?

A full wrap of a Borgward Arabella takes about 41 ft (12.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film to cover the bright trim, the figure rises to about 52 ft (16 m). These amounts are based on the only body style in the catalog, the two-door sedan from 1959–1963.

Can I wrap only the hood or the roof of an Arabella?

Yes, you can wrap only the hood or the roof of an Arabella. A partial wrap can cover the roof, hood, or mirror caps, and the film needed is far less than a full wrap. Chrome delete on the window trim and badges is another small job on this car.

Is an Arabella hard to wrap?

An Arabella is not especially hard to wrap, but a few points add work. The two long side doors are each one large piece of film, so handling them needs care to avoid wrinkles. The compact length of 150.8 in (3,830 mm) keeps the job small, but the chrome window trim and badges require precise cut-outs.

How many generations of the Arabella does this page cover?

This page covers one generation of the Arabella. The catalog includes only the first generation, built from 1959 to 1963.