Wraps by car

Honda MDX wrap

The Honda MDX wrap page covers the first generation of this SUV produced from 2003 to 2006. A full vinyl wrap of this body takes about 64 ft (19.5 m) of 60-inch (1.52 m) cast film. Owners choosing chrome or patterned film can plan for about 72 ft (22 m). The catalog presents one generation with no other bodies listed.

1generations19.5 mof film for a full wrap

Honda MDX, first generation, factory photo
Honda MDX, first generation. Factory color shown.

Honda MDX wrap colors and ideas

  • Honda MDX black wrap
  • Honda MDX white wrap
  • Honda MDX gray wrap
  • Honda MDX silver wrap
  • Honda MDX red wrap
  • Honda MDX blue wrap
  • Honda MDX green wrap
  • Honda MDX yellow wrap
  • Honda MDX orange wrap
  • Honda MDX purple wrap
  • Honda MDX pink wrap
  • Honda MDX teal wrap
  • Honda MDX brown wrap
  • Honda MDX gold wrap
  • Honda MDX chrome wrap
  • Honda MDX color shift wrap
  • Honda MDX carbon fiber wrap
  • Honda MDX camo and patterned wrap

How much vinyl to wrap a Honda MDX

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2003–2006SUV (5 doors)188.6 in (4,790 mm)about 64 ft (19.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m)

Honda MDX wrap cost factors

Honda MDX wrap cost depends on the film type, the shop's labor rate, and the condition of the paint on this first-generation SUV. A standard color change uses about 64 ft (19.5 m) of 60-inch (1.52 m) cast film, while chrome or patterned film raises the material amount to about 72 ft (22 m). Paint correction or panel repair before the wrap adds hours and materials. The five-door body and length of 188.6 in (4,790 mm) also influence the labor charge.

  • Film for a full wrap: about 64 ft (19.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m).
  • Body: SUV (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Honda MDX wraps by generation

Swipe sideways. Tap a card for the full description.

Honda MDX, first generation, factory photo
Factory color shown

2003–2006 Honda MDX SUV (first generation)

2003–2006SUV (5 doors)188.6 in (4,790 mm)

Paint age matters on a first-generation Honda MDX from 2003 to 2006, because panels may be original or repainted. A test spot before a full wrap shows whether the film will lift old paint or leave residue on a resprayed panel. Installers often check adhesion on each door and fender before committing to the job. This step protects the paint and gives the film a clean surface.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 64 ft (19.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m).

Roof, hood, chrome delete and PPF on a Honda MDX

A partial wrap on a Honda MDX can cover the roof, the hood, or the mirror caps. A chrome delete changes the window trim and badges to black film. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips. These smaller jobs use less material than a full wrap and can refresh the look of this SUV.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Honda MDX: body, cut-outs and film

A Honda MDX vinyl wrap on this first-generation body covers an SUV with five doors and a length of 188.6 in (4,790 mm). The tall sides and large tailgate make the wrap straightforward but add surface area compared with a sedan. Installers work panel by panel, so the five-door layout creates more cut lines than a coupe. The size means a full wrap uses more film than smaller crossovers.

Honda MDX wrap ideas start with the tailgate, because the rear glass is set into it and the film ends at the edge of the glass. That rear glass needs no cut-out, but the tailgate still has to be wrapped in sections around the handle and lights. Other parts that come off for a clean install include door handles, mirror caps, and badges. Removing these trim pieces lets the film tuck behind edges and reduces visible seams.

How much vinyl to wrap a Honda MDX depends on the generation, and this page covers only the first generation built from 2003 to 2006. With one body style in the catalog, the film estimate stays the same across those years. The 188.6 in (4,790 mm) length and five-door SUV shape set the main material needs. Anyone counting film for a later MDX should check a separate listing.

Questions about wrapping a Honda MDX

How much vinyl does it take to wrap a Honda MDX?

A full Honda MDX wrap takes about 64 ft (19.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, plan for about 72 ft (22 m). These figures are for the first-generation body from 2003 to 2006. Extra material may be needed for mistakes or custom inlays.

Can I wrap only the hood or the roof of a Honda MDX?

Yes, you can wrap only the hood or the roof of a Honda MDX. A partial wrap on these panels uses less film than a full color change. The same partial options include mirror caps and a chrome delete for the window trim and badges. Paint protection film on the front end is another common smaller job.

Is a Honda MDX hard to wrap?

A Honda MDX wrap has one tricky area: the tailgate with the rear glass set into it. The film ends at the edge of the glass, so the installer must cut a clean line around that window. The five-door body and the length of 188.6 in (4,790 mm) add more panels and seams than a small car. Removing door handles and badges also takes extra time.

How many generations of the Honda MDX does this page cover?

This page covers one generation of the Honda MDX, the first generation produced from 2003 to 2006. No other generations are listed in this catalog.