Wraps by car

Honda S-MX wrap

The Honda S-MX wrap page covers the first generation of this boxy minivan, produced from 1996 to 2002. A full vinyl wrap of the newest body takes about 59 ft (18 m) of 60-inch (1.52 m) cast film. Chrome or patterned film increases the estimate to about 69 ft (21 m).

1generations18 mof film for a full wrap

Honda S-MX, first generation, factory photo
Honda S-MX, first generation. Factory color shown.

Honda S-MX wrap colors and ideas

  • S-MX black wrap
  • S-MX white wrap
  • S-MX gray wrap
  • S-MX silver wrap
  • S-MX red wrap
  • S-MX blue wrap
  • S-MX green wrap
  • S-MX yellow wrap
  • S-MX orange wrap
  • S-MX purple wrap
  • S-MX pink wrap
  • S-MX teal wrap
  • S-MX brown wrap
  • S-MX gold wrap
  • S-MX chrome wrap
  • S-MX color shift wrap
  • S-MX carbon fiber wrap
  • S-MX camo and patterned wrap

How much vinyl to wrap a Honda S-MX

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1996–2002van (5 doors)155.5 in (3,950 mm)about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

S-MX wrap cost factors

An S-MX wrap cost depends on the amount of film, the film type, and the labor for the van's size. A full wrap uses about 59 ft (18 m) of 60-inch (1.52 m) cast film, while chrome or patterned film uses about 69 ft (21 m). The tall body and sliding door tracks add time for surface preparation and cutting.

  • Film for a full wrap: about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.
  • A tall body (68.9 in (1,750 mm)): the roof is wrapped from a platform.

S-MX wraps by generation

Swipe sideways. Tap a card for the full description.

Honda S-MX, first generation, factory photo
Factory color shown

1996–2002 S-MX van (first generation)

1996–2002van (5 doors)155.5 in (3,950 mm)

The first generation Honda S-MX is a five-door van with sliding side doors. The door tracks stay bare and decide where the film is cut, so the installer trims along those recesses. Its tall body (68.9 in (1,750 mm)) means the roof is wrapped from a platform.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

A tall body (68.9 in (1,750 mm)): the roof is wrapped from a platform.

Film: about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on an S-MX

For an S-MX partial wrap, you can cover just the roof, hood, or mirror caps. An S-MX chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is another option, applied as clear film on the front end.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Honda S-MX: body, cut-outs and film

A Honda S-MX vinyl wrap suits the van's tall, slab-sided body, which gives the installer large panels to work with. At 155.5 in (3,950 mm) long and 68.9 in (1,750 mm) tall, the five-door van needs careful handling of the roof area. The boxy shape simplifies templating because there are few compound curves. The sliding side doors require cuts along the tracks, leaving those recesses bare.

S-MX wrap ideas often start with the sliding side doors, where the door tracks stay bare and decide where the film is cut. The door handles, mirrors, badges, and roof rails (if fitted) come off for a clean installation. The tall body means the roof is wrapped from a platform for safe access.

If you are figuring how much vinyl to wrap an S-MX, note that all production years share the same RH1 body. There is only one generation in the catalog, so the film estimate stays consistent across 1996–2002 models. The main variable is the chosen film width and whether you add patterns or chrome.

Questions about wrapping a Honda S-MX

How much vinyl does it take to wrap a Honda S-MX?

About 59 ft (18 m) of 60-inch (1.52 m) cast film wraps a Honda S-MX fully. If you use chrome or patterned film, the estimate goes up to about 69 ft (21 m). The taller body and sliding door tracks add some waste to the total.

Are the sliding doors of an S-MX wrapped?

Yes, the sliding doors of an S-MX are wrapped, but the tracks stay bare. The film is cut along the door tracks so the doors can still slide freely.

Can I wrap only the hood or the roof of an S-MX?

Yes, you can wrap only the hood or the roof of an S-MX. Partial wrap options include the roof, hood, and mirror caps, while a chrome delete covers window trim and badges.

Is an S-MX hard to wrap?

An S-MX is not especially hard to wrap, but its tall body adds work. The roof is wrapped from a platform because the van stands 68.9 in (1,750 mm) tall. The sliding door tracks require careful cutting along the recesses.