Start an X-Bow wrapped in carbon fiber film by choosing the finish, because the same color change looks very different as a weave or a forged carbon. The weave option reads as a classic motorsport texture and the forged option as a modern, stippled finish. Once the finish is set, pick a film line for its exact shade and surface. Then decide between a full wrap or a partial wrap on selected panels.

Factory paint condition decides how a carbon fiber film will sit, especially on the flat, exposed panels of this convertible. Any chip or scratch shows through the film, so the body needs correction before installation. Seams are few on the X-Bow because the single-piece hood and rear deck take large pieces of film. The fabric top is not wrapped, so the film ends cleanly where the top begins.

A carbon fiber wrap is removable, which makes it a reversible change to the X-Bow. Removing the film returns the body to its factory paint when the film was installed over sound paint. Hand wash the wrapped body because brushes can lift the film edges at the panel gaps. Use a pH-neutral soap and a soft mitt to keep the textured surface clean.