Wraps by car

Audi V8 wrap

The Audi V8 wrap page covers the first generation produced from 1988 to 1994, a luxury sedan. This model had one generation in our catalog. A full wrap of the body takes about 57 ft (17.5 m) of 60-inch (1.52 m) cast vinyl film.

1generations17.5 mof film for a full wrap

Audi V8, first generation, factory photo
Audi V8, first generation. Factory color shown.

Audi V8 wrap colors and ideas

  • Audi V8 black wrap
  • Audi V8 white wrap
  • Audi V8 gray wrap
  • Audi V8 silver wrap
  • Audi V8 red wrap
  • Audi V8 blue wrap
  • Audi V8 green wrap
  • Audi V8 yellow wrap
  • Audi V8 orange wrap
  • Audi V8 purple wrap
  • Audi V8 pink wrap
  • Audi V8 teal wrap
  • Audi V8 brown wrap
  • Audi V8 gold wrap
  • Audi V8 chrome wrap
  • Audi V8 color shift wrap
  • Audi V8 carbon fiber wrap
  • Audi V8 camo and patterned wrap

How much vinyl to wrap an Audi V8

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1988–1994sedan (4 doors)191.9 in (4,874 mm) to 204.3 in (5,190 mm)about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m)

Audi V8 wrap cost factors

Audi V8 wrap cost depends on the film chosen: cast color film needs about 57 ft (17.5 m), while chrome or patterned film needs about 70 ft (21.5 m). The installer's work to remove and refit the bumpers, mirrors and door handles adds to the cost. Panel condition matters, as bodywork on a car of these years can add time before wrapping.

  • Film for a full wrap: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).
  • Body: sedan (4 doors).

Audi V8 wraps by generation

Swipe sideways. Tap a card for the full description.

Audi V8, first generation, factory photo
Factory color shown

1988–1994 Audi V8 sedan (first generation)

1988–1994sedan (4 doors)191.9 in (4,874 mm) to 204.3 in (5,190 mm)

The first-generation Audi V8 from 1988 to 1994 is a sedan with four doors and two possible lengths. Panels may be original or repainted after three decades, so a test spot for paint adhesion is wise before a full wrap. The long-wheelbase version adds about a foot of length that the installer must cover.

Film: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).

Roof, hood, chrome delete and PPF on an Audi V8

For an Audi V8, a partial wrap can cover the roof, hood or mirror caps in one color or a contrast film. Chrome delete wraps the window trim and badges in black film, removing bright accents. Paint protection film (PPF) is a clear shield applied to the front end, including the hood, fenders and bumper.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping an Audi V8: body, cut-outs and film

An Audi V8 vinyl wrap covers a large four-door sedan measuring 191.9 in (4,874 mm) to 204.3 in (5,190 mm) long. The long wheelbase version adds surface area to the roof and lower doors. Four doors and a full-length trunk mean more film and more seams than a small car.

Audi V8 wrap ideas start with removing the door handles, belt mouldings and side mirrors for a clean job. The wrap specialist takes off the bumpers on this model to tuck film edges where stone chips begin. The window trim and badges need careful cutting or removal for a smooth chrome delete.

To work out how much vinyl to wrap an Audi V8, note that only one generation exists from 1988 to 1994. The sedan body was offered in two lengths, and the long version needs extra film for the doors and roof. A first-generation car with original paint may need more prep before film goes on.

Questions about wrapping an Audi V8

How much vinyl does it take to wrap an Audi V8?

Yes, a full wrap of an Audi V8 takes about 57 ft (17.5 m) of 60-inch (1.52 m) cast film. Use about 70 ft (21.5 m) if the design is chrome or patterned because the installer needs extra to match direction and avoid seams.

Can I wrap only the hood or the roof of an Audi V8?

Yes, a hood or roof wrap is a common partial job on the Audi V8. The roof of the long-wheelbase sedan still takes far less film than a full wrap, and a hood wrap can protect the paint under a clear film instead.

Is an Audi V8 hard to wrap?

The Audi V8 is not the hardest sedan to wrap, but its age and size add work. The bumpers, mirrors and door handles come off for a neat job, and a test spot is needed if the paint is original or repainted. Extra length on the long-wheelbase model means more careful film handling.

How many generations of the Audi V8 does this page cover?

This page covers one generation of the Audi V8: the first generation produced from 1988 to 1994.