Wraps by car

Maruti Suzuki Esteem wrap

The Maruti Suzuki Esteem wrap page covers the first generation sedan sold from 1994 to 2007, a single body style. A full vinyl wrap of this compact sedan takes about 46 ft (14 m) of 60-inch (1.52 m) cast film. With chrome or patterned film, plan for about 56 ft (17 m) to cover the same body.

1generations14 mof film for a full wrap

Maruti Suzuki Esteem, first generation, factory photo
Maruti Suzuki Esteem, first generation. Factory color shown.

Maruti Suzuki Esteem wrap colors and ideas

  • Esteem black wrap
  • Esteem white wrap
  • Esteem gray wrap
  • Esteem silver wrap
  • Esteem red wrap
  • Esteem blue wrap
  • Esteem green wrap
  • Esteem yellow wrap
  • Esteem orange wrap
  • Esteem purple wrap
  • Esteem pink wrap
  • Esteem teal wrap
  • Esteem brown wrap
  • Esteem gold wrap
  • Esteem chrome wrap
  • Esteem color shift wrap
  • Esteem carbon fiber wrap
  • Esteem camo and patterned wrap

How much vinyl to wrap a Maruti Suzuki Esteem

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1994–2007sedan (4 doors)160.4 in (4,075 mm)about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 56 ft (17 m)

Esteem wrap cost factors

An Esteem wrap cost depends on the film type, the number of panels and the condition of the paint on this car. A full color change wrap on the 160.4 in (4,075 mm) sedan uses about 46 ft (14 m) of film, while chrome or patterned film pushes the estimate to 56 ft (17 m). The shop will spend more time preparing a 1994–2007 car with rough or repainted panels, which raises the labor part of the cost. A partial wrap on the hood and roof uses less film and is a smaller job than the full wrap.

  • Film for a full wrap: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 56 ft (17 m).
  • Body: sedan (4 doors).

Esteem wraps by generation

Swipe sideways. Tap a card for the full description.

Maruti Suzuki Esteem, first generation, factory photo
Factory color shown

1994–2007 Esteem sedan (first generation)

1994–2007sedan (4 doors)160.4 in (4,075 mm)

The first generation Maruti Suzuki Esteem was produced from 1994 to 2007 as a four-door compact sedan. On a car of these years panels may be original or repainted, and a test spot comes before a full wrap. The installer will check a small area for paint lifting or old clear coat failure before the film is applied. Any rust or deep scratches under the film will show through, so the surface needs repair first.

Film: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 56 ft (17 m).

Roof, hood, chrome delete and PPF on an Esteem

A partial wrap on a Maruti Suzuki Esteem can cover the roof, the hood or the mirror caps as a color change. A chrome delete covers the window trim and the badges with black film and is a quick way to change the look of this sedan. Paint protection film (PPF) is a clear film applied to the front end of the Esteem to protect the bumper, the hood and the fenders. Each of these jobs uses less film than a full wrap and can be done without wrapping the whole car.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Maruti Suzuki Esteem: body, cut-outs and film

A Maruti Suzuki Esteem vinyl wrap starts with a four-door sedan body that is 160.4 in (4,075 mm) long. The flat sides and simple bumpers of this compact car keep the film layout straightforward. The roof and the rear pillars are small enough to wrap from a single sheet of 60-inch film. The four door handles and the mirror caps add a few small pieces that are cut and applied separately.

Esteem wrap ideas begin with the chrome trim on the grille, the window beltline and the badges, which can be covered with black film. The door handles and the mirror caps come off easily for a cleaner edge, and the headlights and tail lights need cut-outs in the film. The front and rear bumpers wrap best as one piece each, with the film tucked behind the edges. The side mouldings can be wrapped on the car or removed and reinstalled after the film is applied.

To work out how much vinyl to wrap an Esteem, use the film estimate for this car: 46 ft (14 m) of 60-inch (1.52 m) film. The single generation of the Esteem kept the same body shell for all production years, so the estimate holds for every 1994 to 2007 car. Small trim differences between early and late cars do not change the amount of film on the large panels. Add extra film if you plan to wrap the door jambs or the inside of the trunk lid.

Questions about wrapping a Maruti Suzuki Esteem

How much vinyl does it take to wrap a Maruti Suzuki Esteem?

Yes, a full wrap of a Maruti Suzuki Esteem uses about 46 ft (14 m) of 60-inch (1.52 m) cast film. Chrome or patterned film takes more material, about 56 ft (17 m), because the pattern has to be matched at the seams. The figure covers the outside of the sedan body from the 1994–2007 generation.

Can I wrap only the hood or the roof of an Esteem?

Yes, you can wrap only the hood or the roof of an Esteem as a partial wrap. A partial wrap on this car can also cover the mirror caps, or you can have a chrome delete on the window trim and badges. Paint protection film (PPF) on the front end is another option that does not involve wrapping the whole car.

Is an Esteem hard to wrap?

An Esteem is not a hard car to wrap for a shop with compact sedan experience, but the age of the paint adds work. The single body style from 1994 to 2007 has flat panels and a 160.4 in (4,075 mm) length, which keeps the film layout simple. The chrome trim and the badges need careful cut-outs or removal, and the paint may need a test spot before the full wrap.

How many generations of the Esteem does this page cover?

This page covers one generation of the Maruti Suzuki Esteem, the first generation sold from 1994 to 2007. The catalog lists a single body style for that generation, the four-door sedan.