Wraps by car

Saab 96 wrap

This page covers the Saab 96 and its vinyl wrap options. The Saab 96 was produced from 1960 to 1980 in one generation. A full wrap of the coupe body takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film needs about 54 ft (16.5 m).

1generations13.5 mof film for a full wrap

Saab 96, first generation, factory photo
Saab 96, first generation. Factory color shown.

Saab 96 wrap colors and ideas

  • Saab 96 black wrap
  • Saab 96 white wrap
  • Saab 96 gray wrap
  • Saab 96 silver wrap
  • Saab 96 red wrap
  • Saab 96 blue wrap
  • Saab 96 green wrap
  • Saab 96 yellow wrap
  • Saab 96 orange wrap
  • Saab 96 purple wrap
  • Saab 96 pink wrap
  • Saab 96 teal wrap
  • Saab 96 brown wrap
  • Saab 96 gold wrap
  • Saab 96 chrome wrap
  • Saab 96 color shift wrap
  • Saab 96 carbon fiber wrap
  • Saab 96 camo and patterned wrap

How much vinyl to wrap a Saab 96

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1960–1980coupe (2 doors)164.2 in (4,170 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m)

Saab 96 wrap cost factors

Saab 96 wrap cost depends on the film used, the condition of the paint, and the amount of surface covered. The car is 164.2 in (4,170 mm) long and takes about 44 ft (13.5 m) of 60-inch (1.52 m) film for a full wrap. Chrome or patterned film increases the film needed to about 54 ft (16.5 m). Labor time rises with paint chips, rust, or dents that need repair before wrapping.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Saab 96 wraps by generation

Swipe sideways. Tap a card for the full description.

Saab 96, first generation, factory photo
Factory color shown

1960–1980 Saab 96 coupe (first generation)

1960–1980coupe (2 doors)164.2 in (4,170 mm)

The first generation Saab 96 was built from 1960 to 1980 as a two-door coupe. On a car of these years the paint may be original or repainted, so a test spot comes before a full wrap. Old paint can be brittle and may lift when the film is repositioned. A test spot shows whether the paint will hold to the adhesive.

Two long side doors: each door is one large piece of film.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).

Roof, hood, chrome delete and PPF on a Saab 96

Partial wrap jobs on a Saab 96 cover the roof, hood, or mirror caps, and a chrome delete covers window trim and badges. Paint protection film (PPF) as a clear film on the front end protects the hood and fenders from stone chips. These smaller jobs use less film than a full wrap and focus on the most visible or vulnerable areas.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Saab 96: body, cut-outs and film

A Saab 96 vinyl wrap requires film for a compact two-door coupe. The car is 164.2 in (4,170 mm) long with two long side doors. Each side door is one large piece of film, not several small panels. The body has no complex curves around doors or bumpers.

Saab 96 wrap ideas include highlighting the long doors and simple roofline. The two long side doors each take one large piece of film, so seams are easy to place where the body lines run. The front and rear windows need cut-outs around the rubber seals, and the door handles come off for a clean edge. The bumpers can stay on, but wrapping around them takes patience.

To know how much vinyl to wrap a Saab 96, start with the full body estimate. The only body is the two-door coupe from 1960 to 1980, so the film amount does not change between generations. A full wrap takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Buy that amount plus a little extra for mistakes.

Questions about wrapping a Saab 96

How much vinyl does it take to wrap a Saab 96?

A Saab 96 full wrap takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. If you use chrome or patterned film, plan for about 54 ft (16.5 m). Always add a little extra for seams and mistakes.

Can I wrap only the hood or the roof of a Saab 96?

Yes, you can wrap only the hood or the roof of a Saab 96. These are partial wrap jobs that cover the roof, hood, or mirror caps. You can also do a chrome delete on window trim and badges or apply paint protection film to the front end.

Is a Saab 96 hard to wrap?

A Saab 96 is not hard to wrap if you plan for the long doors and old paint. The two long side doors each need one large piece of film, which takes two people to handle without wrinkles. The car is 164.2 in (4,170 mm) long, so you need space to lay out large panels. Paint age is a concern: test a spot before the full wrap.

How many generations of the Saab 96 does this page cover?

This page covers one generation of the Saab 96, from 1960 to 1980. The car was a two-door coupe for all those years with the same body style. Film amounts are the same for every car of that generation.