Wraps by car

Talbot Solara wrap

The Talbot Solara wrap page covers the first generation of this mid-size hatchback, produced from 1980 to 1986. A full vinyl wrap of the Solara takes about 51 ft (15.5 m) of 60-inch (1.52 m) cast film. If you choose a chrome or patterned film, plan for about 62 ft (19 m). This page explains the body details that affect wrapping this car.

1generations15.5 mof film for a full wrap

Talbot Solara, first generation, factory photo
Talbot Solara, first generation. Factory color shown.

Talbot Solara wrap colors and ideas

  • Solara black wrap
  • Solara white wrap
  • Solara gray wrap
  • Solara silver wrap
  • Solara red wrap
  • Solara blue wrap
  • Solara green wrap
  • Solara yellow wrap
  • Solara orange wrap
  • Solara purple wrap
  • Solara pink wrap
  • Solara teal wrap
  • Solara brown wrap
  • Solara gold wrap
  • Solara chrome wrap
  • Solara color shift wrap
  • Solara carbon fiber wrap
  • Solara camo and patterned wrap

How much vinyl to wrap a Talbot Solara

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1980–1986hatchback (5 doors)173.0 in (4,394 mm)about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m)

Solara wrap cost factors

Solara wrap cost depends on the size of the car, the film type, and how much of the body is covered. The full body is 173.0 in (4,394 mm) long and needs about 51 ft (15.5 m) of 60-inch (1.52 m) film. A chrome or patterned wrap takes about 62 ft (19 m) because the pattern must line up. A partial wrap uses less film, so the cost is lower.

  • Film for a full wrap: about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m).
  • Body: hatchback (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Solara wraps by generation

Swipe sideways. Tap a card for the full description.

Talbot Solara, first generation, factory photo
Factory color shown

1980–1986 Solara hatchback (first generation)

1980–1986hatchback (5 doors)173.0 in (4,394 mm)

The first generation Talbot Solara was built from 1980 to 1986 as a five-door hatchback. On a car of these years, the paint may be original or repainted, so a test spot comes before a full wrap. The wrap film sticks to a clean, smooth surface, and a test spot shows how the paint holds. This step avoids lifting the paint when the film is removed.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m).

Roof, hood, chrome delete and PPF on a Solara

A partial wrap on a Talbot Solara covers the roof, hood, or mirror caps. A chrome delete is also possible, where bright window trim and badges are covered with black film. Paint protection film (PPF) is a clear film that can be applied to the front end. These jobs use less material than a full wrap and change the look or protect the paint.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Talbot Solara: body, cut-outs and film

The Talbot Solara vinyl wrap follows the simple shape of a five-door hatchback body. The car is 173.0 in (4,394 mm) long, which is a typical mid-size length for a wrap. The straight sides and moderate curves make film application straightforward for an experienced installer. A full wrap of this body uses about 51 ft (15.5 m) of 60-inch (1.52 m) film.

Solara wrap ideas start with the tailgate, which has the rear glass set into it. The film ends at the edge of that glass, so the tailgate needs a careful cut line around the window. The door handles, mirrors, and trim pieces are removed for a clean wrap. This leaves fewer edges to lift and keeps the film tight.

How much vinyl to wrap a Solara depends on the film you pick. The first generation is the only body this page covers, so the estimate stays the same for every 1980–1986 car. A standard color change wrap needs about 51 ft (15.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds waste, so you would order about 62 ft (19 m).

Questions about wrapping a Talbot Solara

How much vinyl does it take to wrap a Talbot Solara?

It takes about 51 ft (15.5 m) of 60-inch (1.52 m) cast film to wrap a Talbot Solara in a standard color change wrap. If you use chrome or patterned film, the amount is about 62 ft (19 m) because of pattern matching. These figures are for the first generation five-door hatchback from 1980 to 1986.

Can I wrap only the hood or the roof of a Solara?

Yes, you can wrap only the hood or the roof of a Solara. A partial wrap on this car often includes the roof, hood, or mirror caps. You can also choose a chrome delete for the window trim and badges. These smaller jobs use less film than a full wrap.

Is a Solara hard to wrap?

The Solara is not very hard to wrap, but the tailgate adds some work. The rear glass is set into the tailgate, so the film must be cut at the edge of the glass. The car is 173.0 in (4,394 mm) long, and a full wrap uses about 51 ft (15.5 m) of 60-inch (1.52 m) film. With the right preparation, an experienced installer can wrap it cleanly.

How many generations of the Solara does this page cover?

This page covers one generation of the Talbot Solara. The first generation, from 1980 to 1986, is the only body in the catalog. It is a five-door hatchback with a tailgate that includes the rear glass.