Wraps by car

Talbot Tagora wrap

A Talbot Tagora wrap covers the full-size sedan produced from 1980 to 1987, the only generation in this catalog. A full vinyl wrap of the 190.1 in (4,828 mm) body takes about 59 ft (18 m) of 60-inch cast film. Adding chrome or patterned film raises the estimate to about 69 ft (21 m).

1generations18 mof film for a full wrap

Talbot Tagora, first generation, factory photo
Talbot Tagora, first generation. Factory color shown.

Talbot Tagora wrap colors and ideas

  • Tagora black wrap
  • Tagora white wrap
  • Tagora gray wrap
  • Tagora silver wrap
  • Tagora red wrap
  • Tagora blue wrap
  • Tagora green wrap
  • Tagora yellow wrap
  • Tagora orange wrap
  • Tagora purple wrap
  • Tagora pink wrap
  • Tagora teal wrap
  • Tagora brown wrap
  • Tagora gold wrap
  • Tagora chrome wrap
  • Tagora color shift wrap
  • Tagora carbon fiber wrap
  • Tagora camo and patterned wrap

How much vinyl to wrap a Talbot Tagora

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1980–1987sedan (4 doors)190.1 in (4,828 mm)about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Tagora wrap cost factors

Tagora wrap cost depends on the size of the car and the amount of film used. A full wrap needs about 59 ft (18 m) of 60-inch cast film, or about 69 ft (21 m) if chrome or patterned film is used. The surface area of the 190.1 in (4,828 mm) sedan body is the main driver. Film choice and the number of cut-outs also change the time and material.

  • Film for a full wrap: about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: sedan (4 doors).

Tagora wraps by generation

Swipe sideways. Tap a card for the full description.

Talbot Tagora, first generation, factory photo
Factory color shown

1980–1987 Tagora sedan (first generation)

1980–1987sedan (4 doors)190.1 in (4,828 mm)

The first generation Talbot Tagora was sold from 1980 to 1987 as a four-door sedan. Paint age on a car of these years may be original or repainted, so a test spot comes before a full wrap. Old paint can be brittle and may lift when film is repositioned. A small adhesion test on a low panel shows if the surface is sound.

Film: about 59 ft (18 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on a Tagora

A partial wrap on a Talbot Tagora covers the roof, hood, or mirror caps in vinyl. Chrome delete covers the window trim and badges with black film. Paint protection film (PPF), a clear film, goes on the front end to guard against stone chips. These jobs use less material than a full wrap and are often done in one day.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Talbot Tagora: body, cut-outs and film

The Talbot Tagora vinyl wrap follows the simple four-door sedan shape of the 1980–1987 model. The body is 190.1 in (4,828 mm) long, so film is cut in long, straight runs over the roof and sides. There are no long roof rails or flared arches to fight, which keeps material waste low. A single roll of 60-inch film is enough for the full body.

Tagora wrap ideas start with the bright trim and badges, which need careful cut-outs or removal. Window trim and badges are small, sharp pieces that lift if the surface is not cleaned well. Door handles and mirrors are easier to remove for a clean edge. The body sides are flat, so the main panels go on without heat.

How much vinyl to wrap a Tagora stays the same for all years, because the catalog lists one generation. The 1980–1987 sedan has the same 190.1 in (4,828 mm) length and four-door body throughout. A wrapper can order the same film estimate for any Tagora from that period. No short or long wheelbase version appears in this catalog.

Questions about wrapping a Talbot Tagora

How much vinyl does it take to wrap a Talbot Tagora?

A full wrap of a Talbot Tagora takes about 59 ft (18 m) of 60-inch (1.52 m) cast film. Chrome or patterned film raises the estimate to about 69 ft (21 m). These figures cover the 1980–1987 sedan body, which is 190.1 in (4,828 mm) long.

Can I wrap only the hood or the roof of a Tagora?

Yes, you can wrap only the hood or the roof of a Tagora. These are the main panels offered as a partial wrap, along with mirror caps. A chrome delete on the window trim and badges is also a smaller job. Clear paint protection film on the front end protects without changing the color.

Is a Tagora hard to wrap?

A Tagora is not hard to wrap, but its age adds work. The 1980–1987 sedan has flat, long panels that take film well, yet old paint may be brittle. A test spot is needed before the full wrap to check paint adhesion. The many small bright trim pieces also take time for cut-outs.

How many generations of the Tagora does this page cover?

This page covers one generation of the Talbot Tagora. The first generation was produced from 1980 to 1987 as a four-door sedan. No other generations are listed in this catalog.