Wraps by car

Daimler X308 wrap

This page covers the Daimler X308 wrap in vinyl, covering the 1997–2003 luxury sedan. The X308 is the final Daimler based on the Jaguar XJ platform, with one generation in this catalog. A full color change wrap of the newest body takes about 56 ft (17 m) of 60-inch (1.52 m) cast film.

1generations17 mof film for a full wrap

Daimler X308, first generation, factory photo
Daimler X308, first generation. Factory color shown.

Daimler X308 wrap colors and ideas

  • Daimler X308 black wrap
  • Daimler X308 white wrap
  • Daimler X308 gray wrap
  • Daimler X308 silver wrap
  • Daimler X308 red wrap
  • Daimler X308 blue wrap
  • Daimler X308 green wrap
  • Daimler X308 yellow wrap
  • Daimler X308 orange wrap
  • Daimler X308 purple wrap
  • Daimler X308 pink wrap
  • Daimler X308 teal wrap
  • Daimler X308 brown wrap
  • Daimler X308 gold wrap
  • Daimler X308 chrome wrap
  • Daimler X308 color shift wrap
  • Daimler X308 carbon fiber wrap
  • Daimler X308 camo and patterned wrap

How much vinyl to wrap a Daimler X308

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1997–2003sedan (4 doors)202.7 in (5,148 mm)about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m)

Daimler X308 wrap cost factors

Daimler X308 wrap cost depends on film choice, body condition and how much of the brightwork you cover. A full color change wrap of this 202.7 in (5,148 mm) sedan takes about 56 ft (17 m) of cast film. Patterned or chrome film raises the material amount to about 70 ft (21.5 m) and adds labor for aligning the pattern. Paint age and previous repairs also affect the preparation time, because loose or cracked paint must be fixed before the vinyl goes on.

  • Film for a full wrap: about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).
  • Body: sedan (4 doors).

Daimler X308 wraps by generation

Swipe sideways. Tap a card for the full description.

Daimler X308, first generation, factory photo
Factory color shown

1997–2003 Daimler X308 sedan (first generation)

1997–2003sedan (4 doors)202.7 in (5,148 mm)

This first generation Daimler X308 was built from 1997 to 2003, and paint age is a key point for wrapping. Panels may be original or repainted after years on the road, and a test spot tells you if the surface will hold vinyl. Older clear coat can lift when you reposition the film, so the installer works slowly on weak areas. If the paint is sound, the long flat panels of the sedan accept the wrap well.

Film: about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).

Roof, hood, chrome delete and PPF on a Daimler X308

A partial wrap on a Daimler X308 covers the roof, hood or mirror caps without wrapping the whole car. A chrome delete on the window trim and badges is a small job that changes the look of this luxury sedan. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips. Each of these jobs uses less vinyl than a full wrap and still personalizes the car.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Daimler X308: body, cut-outs and film

The Daimler X308 vinyl wrap fits one body style: a four-door sedan with a long 202.7 in (5,148 mm) body. The large roof, hood and rear quarters make up most of the film use. Long lower doors call for wide vinyl sections, so waste is low when you plan the cuts. Because there is no wagon or coupe, a single set of panel templates covers every X308.

Daimler X308 wrap ideas begin with the parts that need cut-outs or come off. Door handles, lock barrels, side repeaters and the leaper ornament on the hood all need precise cuts. The chrome grille, window trim and trunk plinth are best removed for a clean wrap. Bumper inserts and side skirts come off too, which makes the vinyl tuck neatly at the edges.

To work out how much vinyl to wrap a Daimler X308, you need only this one generation from 1997 to 2003. The body shell did not change through the run, so the film estimate stays the same for every year. Some trims add chrome trim pieces that use more film if you cover them. A patterned or chrome film wrap calls for about 70 ft (21.5 m) because the pattern must line up.

Questions about wrapping a Daimler X308

How much vinyl does it take to wrap a Daimler X308?

Yes, a full wrap of a Daimler X308 takes about 56 ft (17 m) of 60-inch (1.52 m) cast film. This figure covers the whole sedan body, including doors, fenders, hood, trunk, bumpers and rockers. For chrome or patterned film, plan for about 70 ft (21.5 m) to allow pattern matching.

Can I wrap only the hood or the roof of a Daimler X308?

Yes, you can wrap only the hood or the roof of a Daimler X308 as a partial wrap. The partial jobs for this car are the roof, hood and mirror caps, alone or together. A chrome delete covers the window trim and badges, and paint protection film (PPF) is a clear film for the front end.

Is a Daimler X308 hard to wrap?

A Daimler X308 is not especially hard to wrap, but its size and details add work. The 202.7 in (5,148 mm) body means large panels that need two installers for a smooth finish. Door handles, lock barrels, side repeaters and the hood ornament call for careful cut-outs, and removing the chrome trim takes extra time.

How many generations of the Daimler X308 does this page cover?

This page covers one generation of the Daimler X308, the first and only generation built from 1997 to 2003. The sedan body shell stayed the same through those years, so the wrap data apply to every X308. There are no earlier or later generations of this model in the catalog.