Wraps by car

Jaguar Mark IV wrap

The Jaguar Mark IV wrap page covers the first generation sedan produced from 1936 to 1949. A full vinyl wrap of this car takes about 54 ft (16.5 m) of 60-inch (1.52 m) cast film. The page covers one generation of the Mark IV.

1generations16.5 mof film for a full wrap

Jaguar Mark IV, first generation, factory photo
Jaguar Mark IV, first generation. Factory color shown.

Jaguar Mark IV wrap colors and ideas

  • Mark IV black wrap
  • Mark IV white wrap
  • Mark IV gray wrap
  • Mark IV silver wrap
  • Mark IV red wrap
  • Mark IV blue wrap
  • Mark IV green wrap
  • Mark IV yellow wrap
  • Mark IV orange wrap
  • Mark IV purple wrap
  • Mark IV pink wrap
  • Mark IV teal wrap
  • Mark IV brown wrap
  • Mark IV gold wrap
  • Mark IV chrome wrap
  • Mark IV color shift wrap
  • Mark IV carbon fiber wrap
  • Mark IV camo and patterned wrap

How much vinyl to wrap a Jaguar Mark IV

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1936–1949sedan (4 doors)172.8 in (4,390 mm)about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m)

Mark IV wrap cost factors

Mark IV wrap cost depends on film area, film type, and the labor of working on an older body. The sedan needs about 54 ft (16.5 m) of cast film, and chrome or patterned film pushes that to about 62 ft (19 m). Removing aged trim and dealing with paint condition can also change the final labor figure.

  • Film for a full wrap: about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m).
  • Body: sedan (4 doors).

Mark IV wraps by generation

Swipe sideways. Tap a card for the full description.

Jaguar Mark IV, first generation, factory photo
Factory color shown

1936–1949 Mark IV sedan (first generation)

1936–1949sedan (4 doors)172.8 in (4,390 mm)

The first-generation Jaguar Mark IV was built as a four-door sedan from 1936 to 1949. Paint age on a car of these years varies: panels may be original or repainted, so a test spot comes before a full wrap. Check adhesion on each panel, especially if the surface shows cracks or old touch-ups. A test spot also shows whether any old paint pulls away when the film is lifted.

Film: about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m).

Roof, hood, chrome delete and PPF on a Mark IV

Partial wrap options for the Mark IV include the roof, hood, and mirror caps. Chrome delete covers window trim and badges with black film. Paint protection film (PPF) applies clear film on the front end to guard against stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Jaguar Mark IV: body, cut-outs and film

A Jaguar Mark IV vinyl wrap is shaped by the car's four-door sedan body and its length of 172.8 in (4,390 mm). The long roof and tall doors add surface area, so installers plan more film and more working time. The body has fewer complex curves than modern cars, but the older metal may show more texture through the film.

Mark IV wrap ideas start with the parts that need cut-outs or come off for a clean install. Door handles, badges, and trim should be removed before wrapping the panels. The large chrome grille and separate fenders need careful film relief cuts to avoid lifting at the edges.

To know how much vinyl to wrap a Mark IV, count one body generation only: the first generation sedan from 1936 to 1949. Changes within these years are small and do not alter the outer dimensions used for film estimates. A full wrap of any Mark IV uses the same base film amount, but always confirm measurements on the car before cutting.

Questions about wrapping a Jaguar Mark IV

How much vinyl does it take to wrap a Jaguar Mark IV?

A Jaguar Mark IV wrap takes about 54 ft (16.5 m) of 60-inch (1.52 m) cast film. If you use chrome or patterned film, plan for about 62 ft (19 m). The estimate covers the whole sedan body.

Can I wrap only the hood or the roof of a Mark IV?

Yes, you can wrap only the hood or the roof of a Mark IV. The partial wrap list includes the roof, hood, and mirror caps. Chrome delete and clear paint protection film on the front end are also smaller jobs.

Is a Mark IV hard to wrap?

A Mark IV is harder to wrap than a modern car because of its long, flat panels and aged trim that may need removal. The sedan's 172.8 in (4,390 mm) length means more film handling. Old paint can be fragile, so a test spot is needed before the full wrap.

How many generations of the Mark IV does this page cover?

This page covers one generation of the Mark IV: the first-generation sedan produced from 1936 to 1949. No other generations are listed in the catalog.