Wraps by car

Lamborghini Urraco wrap

This page covers the Lamborghini Urraco wrap, a vinyl wrap for the single generation sold from 1972 to 1981. The first generation is a two-door coupe measuring 168.0 inches (4,267 mm) in length. A full wrap of this body takes about 43 feet (13 meters) of 60-inch (1.52 m) cast film.

1generations13 mof film for a full wrap

Lamborghini Urraco, first generation, factory photo
Lamborghini Urraco, first generation. Factory color shown.

Lamborghini Urraco wrap colors and ideas

  • Urraco black wrap
  • Urraco white wrap
  • Urraco gray wrap
  • Urraco silver wrap
  • Urraco red wrap
  • Urraco blue wrap
  • Urraco green wrap
  • Urraco yellow wrap
  • Urraco orange wrap
  • Urraco purple wrap
  • Urraco pink wrap
  • Urraco teal wrap
  • Urraco brown wrap
  • Urraco gold wrap
  • Urraco chrome wrap
  • Urraco color shift wrap
  • Urraco carbon fiber wrap
  • Urraco camo and patterned wrap

How much vinyl to wrap a Lamborghini Urraco

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1972–1981coupe (2 doors)168.0 in (4,267 mm)about 43 ft (13 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m)

Urraco wrap cost factors

The Urraco wrap cost depends on the film type, the condition of the paint, and the amount of disassembly needed. A full color change uses about 43 feet (13 meters) of cast film, while chrome or patterned film requires about 52 feet (16 meters). The two long doors are large single pieces that add labor time compared to smaller panels. Vehicles of this age often need extra surface preparation before the film can be applied.

  • Film for a full wrap: about 43 ft (13 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Urraco wraps by generation

Swipe sideways. Tap a card for the full description.

Lamborghini Urraco, first generation, factory photo
Factory color shown

1972–1981 Urraco coupe (first generation)

1972–1981coupe (2 doors)168.0 in (4,267 mm)

The first generation Lamborghini Urraco was built from 1972 to 1981, and paint age is a real factor on a car of these years. Panels may be original or repainted, and a test spot comes before a full wrap to check adhesion. The body is a two-door coupe that is 168.0 inches (4,267 mm) long, and a full wrap takes about 43 feet (13 meters) of 60-inch (1.52 m) film. The two long side doors are each installed as one large piece of film.

Two long side doors: each door is one large piece of film.

Film: about 43 ft (13 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).

Roof, hood, chrome delete and PPF on a Urraco

A partial wrap on the Urraco can cover the roof, the hood, or the mirror caps as separate jobs. A chrome delete covers the window trim and badges with black film. Clear paint protection film (PPF) on the front end is a third option that protects without changing the color. These smaller jobs use less film and are a practical way to address specific areas.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Lamborghini Urraco: body, cut-outs and film

The Lamborghini Urraco vinyl wrap works with a compact coupe body and its two long side doors. The car's 168.0-inch (4,267 mm) length means a full color change wrap uses about 43 feet (13 meters) of 60-inch (1.52 m) film. Each door is one large, flat panel that suits a single piece of film. The rear deck and front hood are sized so a standard roll width covers most panels without seams.

Urraco wrap ideas often start with the two long side doors, since each door is one large piece of film. The front bumper, rear bumper, and rocker panels need careful trimming around openings and edges. The side mirrors, door handles, and window trim should be removed or wrapped as separate small pieces. The front grille area needs relief cuts to let the film sit into the recesses.

For how much vinyl to wrap a Urraco, the single generation from 1972 to 1981 keeps the calculation simple. The coupe body is 168.0 inches (4,267 mm) long, and a full wrap takes about 43 feet (13 meters) of standard cast film. If you choose a chrome or patterned film, order about 52 feet (16 meters) to allow for pattern matching and waste. There are no other body styles or later generations to change the estimate.

Questions about wrapping a Lamborghini Urraco

How much vinyl does it take to wrap a Lamborghini Urraco?

A full wrap of a Lamborghini Urraco takes about 43 feet (13 meters) of 60-inch (1.52 m) cast film. The single first-generation coupe is 168.0 inches (4,267 mm) long, and that figure covers the complete body. For chrome or patterned film, the estimate is about 52 feet (16 meters) to allow for waste.

Can I wrap only the hood or the roof of a Urraco?

Yes, you can wrap only the hood or the roof of a Urraco. A partial wrap covers the roof, the hood, or the mirror caps as separate jobs. You can also choose a chrome delete for the window trim and badges, or clear paint protection film (PPF) on the front end.

Is a Urraco hard to wrap?

The Urraco is not the easiest car to wrap because of its age and panel shapes. The two long side doors are each one large piece of film, which demands careful handling and a second installer. The 168.0-inch (4,267 mm) overall length is modest, but the front and rear bumpers have recesses that need relief cuts. The paint condition on a car from 1972 to 1981 may require extra preparation before wrapping.

How many generations of the Urraco does this page cover?

This page covers one generation of the Lamborghini Urraco, the first generation produced from 1972 to 1981. The car was offered only as a two-door coupe in that period. The single body style means the film estimate stays the same across all years covered.