Wraps by car

Daihatsu Boon Luminas wrap

This page covers the Daihatsu Boon Luminas wrap, a five-door minivan produced from 2008 to 2012. A full wrap of the Boon Luminas takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast vinyl wrap film. The catalog describes one generation with a length of 164.6 in (4,180 mm).

1generations18.5 mof film for a full wrap

Daihatsu Boon Luminas, first generation, factory photo
Daihatsu Boon Luminas, first generation. Factory color shown.

Daihatsu Boon Luminas wrap colors and ideas

  • Boon Luminas black wrap
  • Boon Luminas white wrap
  • Boon Luminas gray wrap
  • Boon Luminas silver wrap
  • Boon Luminas red wrap
  • Boon Luminas blue wrap
  • Boon Luminas green wrap
  • Boon Luminas yellow wrap
  • Boon Luminas orange wrap
  • Boon Luminas purple wrap
  • Boon Luminas pink wrap
  • Boon Luminas teal wrap
  • Boon Luminas brown wrap
  • Boon Luminas gold wrap
  • Boon Luminas chrome wrap
  • Boon Luminas color shift wrap
  • Boon Luminas carbon fiber wrap
  • Boon Luminas camo and patterned wrap

How much vinyl to wrap a Daihatsu Boon Luminas

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2008–2012van (5 doors)164.6 in (4,180 mm)about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m)

Boon Luminas wrap cost factors

Boon Luminas wrap cost depends on the film type, the condition of the paint, and the number of parts removed. The body is 164.6 in (4,180 mm) long, and the sliding doors add labor for cutting around the tracks. A chrome delete on the window trim and badges adds a separate material and time step. Partial coverage, such as the hood or roof, reduces the material needed but not the preparation work.

  • Film for a full wrap: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.

Boon Luminas wraps by generation

Swipe sideways. Tap a card for the full description.

Daihatsu Boon Luminas, first generation, factory photo
Factory color shown

2008–2012 Boon Luminas van (first generation)

2008–2012van (5 doors)164.6 in (4,180 mm)

The first generation Boon Luminas has sliding rear side doors with exposed tracks. The film is cut along the track line so the doors can open and close without dragging. The installer leaves the tracks bare, which defines a visible edge on each side of the van. This body style was available from 2008 to 2012.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Film: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).

Roof, hood, chrome delete and PPF on a Boon Luminas

A partial wrap on a Boon Luminas can cover the roof, hood, or mirror caps while leaving the rest of the paint exposed. A chrome delete covers the window trim and badges with black film for a monochrome look. Paint protection film (PPF) is applied as a clear film on the front end to guard against stone chips. These smaller jobs still require careful trimming around the sliding door tracks if the film reaches them.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Daihatsu Boon Luminas: body, cut-outs and film

A Daihatsu Boon Luminas vinyl wrap covers a van body with five doors and sliding side doors. The 164.6 in (4,180 mm) length means the installer works with large, continuous panels. Film must be cut cleanly along the sliding door tracks, which stay bare. This body style has more vertical surface area than a hatchback, so planning the wrap around the door openings is key.

Boon Luminas wrap ideas should account for the sliding side door tracks, which remain unpainted. The film edges are cut along the track lines so the doors can still slide freely. Door handles, mirrors, and badges need cut-outs or removal for a clean finish. The roof rails, if fitted, also need careful trimming around their mounting points.

How much vinyl to wrap a Boon Luminas depends on whether you choose a standard color change or a chrome or patterned film. For the first generation, estimate about 61 ft (18.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film requires about 70 ft (21.5 m) because of pattern matching waste. The van body has no other variants, so film quantity stays consistent across all trims.

Questions about wrapping a Daihatsu Boon Luminas

How much vinyl does it take to wrap a Daihatsu Boon Luminas?

It takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film to wrap a Daihatsu Boon Luminas. For chrome or patterned film, plan on about 70 ft (21.5 m) due to matching waste.

Are the sliding doors of a Boon Luminas wrapped?

The sliding doors of a Boon Luminas are wrapped on the door panels, but the tracks stay bare. The film is cut along the track lines so the doors can still slide open and closed.

Can I wrap only the hood or the roof of a Boon Luminas?

You can wrap only the hood or the roof of a Boon Luminas as a partial wrap. A partial wrap can also include mirror caps, a chrome delete on window trim and badges, or clear paint protection film on the front end.

Is a Boon Luminas hard to wrap?

The Boon Luminas has extra work because of its sliding side doors. The installer must cut the film precisely along the bare door tracks, which adds time compared to a car with standard doors.