Wraps by car

Hyundai Marcia wrap

The Hyundai Marcia wrap page covers the first generation mid-size sedan built from 1995 to 1998. A full vinyl wrap of this car takes about 52 ft (16 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds roughly 20 percent, so plan for about 64 ft (19.5 m). The car measures 185.0 in (4,700 mm) from bumper to bumper.

1generations16 mof film for a full wrap

Hyundai Marcia, first generation, factory photo
Hyundai Marcia, first generation. Factory color shown.

Hyundai Marcia wrap colors and ideas

  • Marcia black wrap
  • Marcia white wrap
  • Marcia gray wrap
  • Marcia silver wrap
  • Marcia red wrap
  • Marcia blue wrap
  • Marcia green wrap
  • Marcia yellow wrap
  • Marcia orange wrap
  • Marcia purple wrap
  • Marcia pink wrap
  • Marcia teal wrap
  • Marcia brown wrap
  • Marcia gold wrap
  • Marcia chrome wrap
  • Marcia color shift wrap
  • Marcia carbon fiber wrap
  • Marcia camo and patterned wrap

How much vinyl to wrap a Hyundai Marcia

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1995–1998sedan (4 doors)185.0 in (4,700 mm)about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 64 ft (19.5 m)

Marcia wrap cost factors

Marcia wrap cost depends on the film type, the condition of the paint, and the amount of disassembly. The car is 185.0 in (4,700 mm) long, which sets the base material need at about 52 ft (16 m) of 60-inch (1.52 m) cast film. Chrome or patterned film raises the amount to about 64 ft (19.5 m). A car with original paint from 1995–1998 may need more prep time than a newer repaint.

  • Film for a full wrap: about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 64 ft (19.5 m).
  • Body: sedan (4 doors).

Marcia wraps by generation

Swipe sideways. Tap a card for the full description.

Hyundai Marcia, first generation, factory photo
Factory color shown

1995–1998 Marcia sedan (first generation)

1995–1998sedan (4 doors)185.0 in (4,700 mm)

The Hyundai Marcia first generation was made from 1995 to 1998 as a mid-size sedan. Paint age matters on a car of these years because panels may be original or repainted. A test spot on each panel checks that the film bonds without lifting old paint. If the paint is weak, the surface needs correction before the wrap goes on.

Film: about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 64 ft (19.5 m).

Roof, hood, chrome delete and PPF on a Marcia

A partial wrap on a Marcia covers the roof, hood, or mirror caps without wrapping the whole sedan. Marcia chrome delete covers the window trim and badges with black film for a darker look. Paint protection film (PPF) is a clear film for the front end to guard against stone chips. These jobs use less material than a full color change wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Hyundai Marcia: body, cut-outs and film

A Hyundai Marcia vinyl wrap follows the clean shape of a four-door sedan body. The 185.0 in (4,700 mm) length means a standard 60-inch (1.52 m) roll works with careful panel planning. The roof, hood, and trunk are broad enough to use film efficiently. Door handles, mirrors, and the front bumper add a few small pieces.

Marcia wrap ideas start with the panels that need cut-outs or come off for a neat finish. Door handles and locks are removed before film goes over the doors. The side mirrors come off for a clean edge around the mirror base. The front and rear bumpers can stay on the car, but a test patch confirms adhesion on the plastic.

How much vinyl to wrap a Marcia stays the same for the only generation this page covers. The sedan body from 1995 to 1998 has one length and one shape, so the estimate does not change. Count the hood, roof, trunk, and four doors as the main panels. A roll of 52 ft (16 m) leaves little extra, so order full rolls rather than cut sizes.

Questions about wrapping a Hyundai Marcia

How much vinyl does it take to wrap a Hyundai Marcia?

A full Hyundai Marcia wrap takes about 52 ft (16 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, add about 12 ft (3.5 m) more, so roughly 64 ft (19.5 m) in total. The estimate is for the first generation sedan from 1995 to 1998.

Can I wrap only the hood or the roof of a Marcia?

Yes, you can wrap only the hood or the roof of a Marcia. A partial wrap covers the roof, hood, or mirror caps without doing the whole car. The hood is one of the easier panels on this sedan because it has no cut-outs. A roof wrap on a Marcia works well as a stand-alone change.

Is a Marcia hard to wrap?

A Marcia is not hard to wrap, but the door handles and mirrors take extra time. The sedan is 185.0 in (4,700 mm) long, so the roof and sides are long panels that need two people. The front and rear bumpers have curves that require heating and stretching the film. Paint age from 1995–1998 can make prep work longer if the surface is rough.

How many generations of the Marcia does this page cover?

This page covers one generation of the Hyundai Marcia, made from 1995 to 1998. The catalog has a single body style for the Marcia: a four-door mid-size sedan. There is no second generation or facelift listed here.